Question about Philips Magnavox 51MP392H Rear Projection Television
The TV clicks like it is turning on, and the light turns red, but there is no picture and no sound, just a blank screen. Chasis #MAG1_AA. I've read that it could be a power supply problem, or the convergence IC may need replacement, but not sure exactly. What is the problem, and where can I get parts and instructions on how to fix it? Thx!!
If you hear a constant clicking or chirping sound get the chirping TV repair kit from www.TvRepairKits.com
If you have no video - but have audio - its most likey the HVG.
Note: When the video goes out sometimes its hard to tell if you have audio becuase you can't see the screen to change to the correct channel.
Posted on May 14, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: magnavox rear projection
If the red converge will not line up, then there the convergence chips are actually bad - the repair will cost around $700 if you go through a Magnavox authorized service center. I would look at posts by Slinteriors in the Philips or Magnavox rear projection sections - he has some ideas on generic chips that might be had for cheaper.
Posted on Jul 06, 2008
SOURCE: Magnavox 51MP392H/17
yes youre model will need two convergence ICs they are both STK392-120 and you will also need some 6.8 ohm resistors usually two or four resistors will need replacing as well. The site servicemanuals do have all the parts and they do provide free installation instructions with the ICs.
Posted on Sep 03, 2008
The popping sound may have been a capacitor. The chance are the capacitor is in the HV section of the TV set and is part of the supply to the Horizontal section of the TV. First if you do not have electronics experience I would suggest you take the TV to a qualified TV repair shop. OK now if you have electronics experience I would say to unplug the TV, open the set up and do a physical inspection of the TV you will be looking for a capacitor that has exploded; if you find one look at the schematic for the TV and find its value. Then do so checks to find out why did the capacitor explode. Most likely the capacitor exploded because of wear and tear, but it always pays to check. Replace the capacitor with one of the same value and then turn the TV on, use your voltmeter to measure the voltage across the capacitor to make sure its the same or close to the value on the schematic.
These are the basics of what to do
I hope this helps
Posted on Sep 21, 2008
When I turn on my magnavox 51mp392h/17 the sound and picture works but there is a sizzling sound coming from inside of the tv I looked and the sound is coming from what looks like a coil it has 4 lines coming from it 3 of which go to the color projectors and one to what looks like a transformer. Can you help me out?
Posted on Sep 14, 2009
Tips for a great answer:
Aug 21, 2011 | Philips Magnavox 51MP392H Rear Projection...
Feb 09, 2011 | Philips Magnavox 51MP392H Rear Projection...
May 20, 2010 | Philips Magnavox 51MP392H Rear Projection...
Sep 29, 2009 | Philips Magnavox 51MP392H Rear Projection...
Jan 30, 2009 | Philips Magnavox 51MP392H Rear Projection...
Aug 18, 2008 | Televison & Video
Jun 06, 2008 | Televison & Video
576 people viewed this question
Usually answered in minutes!