Aeg lavamat 62800 e50 - Washing Machines

either the pump is blocked so cant pump water out so stops program.or brushes in motor worn down(both cheap fixes)

Family error code E50 means a problem with the washing motor. Family error code E70 means a problem with the NTC sensor. In my experience, E50 is most common fault in worn carbon brushes. But in any case family error code E50 is shown to the customer. In service mode could be: E51,52,53 and 54. The same applies to family E70 error code that will be displayed in service mode as error code E71 or E74.
E50 error code could be: motor winding, power board, tachymetric generator, motor relay on power board, wiring between motor and power board and wiring between tachymetric generator and electronic.
E70 error code could be: faulty NTC sensor, wrong position of NTC sensor or to much limescale on it and finaly wiring between NTC and electronic.

Dado

E50 does mean problem with motor or tachometer placed on the motor. Could be: worn carbon brushes, motor faulty, wiring, electronic faulty.
E70 does mean problem with heating phase.
Could be: NTC sensor faulty or badly positioned, wiring faulty, electronic faulty.

Dado

First of all, read exactly alarm code.
Press "Spin/Rinse hold" button and "Prewash" simultaneously for at least 2 seconds: the LED switch off and then display the
sequence of flashes indicating the alarm.
The alarm sequence is displayed for the time in which the buttons are hold down. During the time the alarm is displayed, the appliance continues to perform the cycle or, if it is in the
selection phase, it keeps in memory the options previously chosen.
E70 - Family alarm code

• E71 - Washing NTC sensor faulty
• E74 - Washing NTC sensor badly positioned

Causes: NTC sensor badly positioned; NTC sensor faulty; wiring faulty; PCB faulty.

E50 - Family alarm code

• E51 - Motor power supply triac short-circuited
• E52 - No signal from motor tachometric generator
• E53 - Motor triac sensing circuit faulty
• E54 - Motor relay contacts sticking

Causes: Motor faulty; wiring faulty; PCB faulty; current leakage from motor or from wiring

Dado

Lavamat?! Where in the *&%^ is this machine from? Yugoslavia! I'm guessing it will not allow water IN Because only the Spin (Centrifuge) cycle works?! So if that is so you need your water inlet valves replaced, there are Two. Even in machines named after a Bar of Soap!

Believe this is a motor fault. Change the brushes as a first fix attempt.

AEG Lavamat 62800 keeps stopping and displaying error E50. What is the problem and how do I fix it?

Waited half hour; on start up F3 had cleared..pump overheat? Suspect sticky pump bearing..new pump.

you can get it at  www.repairclinic.com

hi

dont know if this is the one you need AEG 1000 Washing Machine
you may need to scrool down to download the manual .


riz.