Question about Frigidaire FMV156DC Microwave Oven

1 Answer

I need to change the interior light bulb in my Frigidaire over the counter microwave. The model # is FMV156DCA.

Where is the oven light located and how do I change the bulb? I need to change the interior light bulb in my Frigidaire over the counter microwave. The model # is FMV156DCA.

Posted by on

1 Answer

  • Official Brand Answer
  • 4,342 Answers

Good Morning Evelyn, thank you for allowing me to assist you!

Here are some simple troubleshooting tips to help replace the light bulb on your Frigidaire microwave, FMV156DCA.

    ·First, disconnect power to your microwave. This can be done by either unplugging it or at the circuit breaker panel.
    ·To release cover, remove the screw on the light cover (light cover may become very hot, do not touch glass when light is on).
    ·Remove old light bulb and replace only with equivalent watt bulb available from parts distributor or the manufacturer directly. Bulbs are also available at most hardware stores or lighting centers. Bulbs larger than 30 watts are NOT recommended.
    ·Close light cover and secure with screw removed in step 2.

    I hope this information proves to be helpful. If you have further questions, please do not hesitate to reconnect.

Posted on Nov 27, 2013

×

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Microwave light bulb out

This is simple, and "FixYa" technical staff has clearly not looked at our model.

Take off the vent across the top (three long screws) to expose a single screw over the keypad.

Remove the single screw, and the whole keypad consile will lift up and off, likely hanging by a plastic tab/support on the bottom.

Now you can twist the light bulb plug to remove it from the support structure, change the bulb, and replace all that you've done.

Simple.

Posted on Jul 13, 2009

MicrowaveSvc
  • 9047 Answers

SOURCE: light bulb change

If there's no obvious removable cover over the bulb (and the owner's manual doesn't address it) some disassembly may be required.

Always unplug a microwave before removing or installing any bulbs.

If it's an over the range type, remove the vent grille across the top and see if bulbs can be accessed there. There may be a panel on the bottom covering the light(s), instead.

If not, chances are you'll have to remove it from the wall, then remove the outer cover. If so, the installation instructions are very handy, and it's best to have two people since the microwave can be heavy and awkward.

You can download Frigidaire owner's manual and installation instructions here.

Once it's out of the wall, the outer cover (wrapper) will need to be removed, just as you'll need to do on a counter top model.

The screws you need to remove should be pretty obvious, and a special driver (such as a T20H Torx type or GTXH20-100) may be needed.

Be sure to put all the screws back in the right holes, since some may be special grounding screws.

Bulbs can be had in most grocery stores, hardware stores, home improvement centers, and big box or department stores.

Many models use halogen lamps. You must not touch the new one with your bare skin, as the oils will shorten the bulb life.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Posted on Aug 03, 2008

  • 52 Answers

SOURCE: Frigidaire door/power problem

Sounds like either the latch assembly or hinges too loose to activate the micro switch. TIP: Go to the web and type www.partselect.com enter your model number then scoll down to your part. Click to enlarge exploded diagram on left. Veiw enlarged diagram at top of page. You can print the entire diagram for exact assembly by holding your pointer in the upper left hand corner of diagram. Select the print icon. Now you have what you need. If you found any of these suggestions helpful, please rate my solution. D. Lange

Posted on Apr 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to change the light bulb


What kind of microwave oven is this? A counter-top model or an over-the-range microwave? Do you have a brand and model number? And which light bulb do you want to replace - the cavity light bulb, or the bottom light(s) of an OTR microwave?

Oct 19, 2014 | Microwave Ovens

1 Answer

I have to replace microwave light bulb. It's GE counter top Microwave JES1142PSE model. I hace opened the microwave and have located the bulb,but could not unscrew.I don't know needs to be pul


That exact model number is not showing up, so you may want to check the tag on or in the unit and look here for parts.
Most of the models in this class of ovens were not really made to be serviced, so GE only makes the turntable parts available.
It also sounds like your bulb is an assembly - the socket and bulb and one piece.
So your local appliance parts store should have a generic replacement for it. You should take the bulb.
Be careful when disconnecting the leads.
25cda904-b79e-4cbd-b9b1-5912f97b4016.jpg

Apr 14, 2013 | GE Microwave Ovens

1 Answer

Frigidaire microwave oven


Hello - This may or may not be specifically for your model, however these are generics instructions that I found.

To replace the light bulb to the over the range microwave you will need to follow the steps below:

1. To replace light bulb, first disconnect power to the microwave oven at the circuit breaker panel or by unplugging.

2. Remove the vent grill mounting screws.

3. Pull the vent grill away from the unit.

4. Remove the charcoal filter by pushing it inwards, then turn and pull it away from the unit.

5. Open light cover located behind filter mounting by carefully pulling up on the front edge.

6. Remove old light bulb and replace only with equivalent 30 watt bulb available from part distributor. Bulbs are also available at most hardware stores or lighting centers.

7. Replacing the microwave oven light cover by carefully pushing into place. Replace the charcoal filter. Push the vent grill back into place (engaging both the bottom and top tabs) and replace the vent grill mounting screws.


Note: DO NOT USE BULB LARGER THAN 30 WATTS.

Oct 27, 2012 | Frigidaire FMV152K Microwave Oven

1 Answer

Need to change the light bulb. found it but can't


push in on the bulb and then turn a quarter turn counter-clockwise,its a bayonet base bulb,not a candelabra base like a typical light bulb has

Jul 26, 2010 | GE Spacemaker JVM1640SJ Microwave Oven

1 Answer

Model JVM1790SK 01 Where/how do you change the


This is a pretty bad design, sometimes you can just remove the upper grill and access the light assy. If the panel is to tight to work in to change the light,you get to take the whole micowave down and remove the outer wrapper to change the light bulb. This is also not a standard bulb (part #WB25X10019). You may be able to get one from Lowes or Home Depot actually Sears would be a better bet, otherwise you will need to order one from an appliance parts outlet. Hope this helps and sorry I didn't design the thing I just fix them.

Jan 24, 2010 | GE Advantium 120 Convection/Microwave Oven

2 Answers

Microwave light bulb out


This is simple, and "FixYa" technical staff has clearly not looked at our model.

Take off the vent across the top (three long screws) to expose a single screw over the keypad.

Remove the single screw, and the whole keypad consile will lift up and off, likely hanging by a plastic tab/support on the bottom.

Now you can twist the light bulb plug to remove it from the support structure, change the bulb, and replace all that you've done.

Simple.

Feb 07, 2009 | Frigidaire FMV156DC Microwave Oven

1 Answer

The interior light on my microwave convection oven doesn't light.


If there's no obvious removable cover over the bulb (and the owner's manual doesn't address it) some disassembly may be required.

Always unplug a microwave before removing or installing any bulbs.

On an over the range type, remove the vent grille across the top and see if bulbs can be accessed there. There may be a panel on the bottom covering the light(s), instead.

If not, chances are you'll have to remove it from the wall, then remove the outer cover. If so, the installation instructions are very handy, and it's best to have two people since the microwave can be heavy and awkward.

You can download GE owner's manuals and installation instructions here.

Once it's out of the wall, the outer cover (wrapper) will need to be removed, just as you'll need to do on a counter top model.

Be sure to put all the screws back in the right holes, since some may be special grounding screws.

Bulbs can be had in most grocery stores, hardware stores, home improvement centers, and big box or department stores.

Many models use halogen lamps. You must not touch the new one with your bare skin, as the oils will shorten the bulb life.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Nov 20, 2008 | GE JVM1490 Convection/Microwave Oven

1 Answer

Light bulb change


If there's no obvious removable cover over the bulb (and the owner's manual doesn't address it) some disassembly may be required.

Always unplug a microwave before removing or installing any bulbs.

If it's an over the range type, remove the vent grille across the top and see if bulbs can be accessed there. There may be a panel on the bottom covering the light(s), instead.

If not, chances are you'll have to remove it from the wall, then remove the outer cover. If so, the installation instructions are very handy, and it's best to have two people since the microwave can be heavy and awkward.

You can download Frigidaire owner's manual and installation instructions here.

Once it's out of the wall, the outer cover (wrapper) will need to be removed, just as you'll need to do on a counter top model.

The screws you need to remove should be pretty obvious, and a special driver (such as a T20H Torx type or GTXH20-100) may be needed.

Be sure to put all the screws back in the right holes, since some may be special grounding screws.

Bulbs can be had in most grocery stores, hardware stores, home improvement centers, and big box or department stores.

Many models use halogen lamps. You must not touch the new one with your bare skin, as the oils will shorten the bulb life.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Aug 03, 2008 | Frigidaire FMV156DC Microwave Oven

Not finding what you are looking for?
Frigidaire FMV156DC Microwave Oven Logo

518 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Microwave Ovens Experts

William Miller
William Miller

Level 3 Expert

9047 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Jaime Hernandez

Level 3 Expert

2315 Answers

Are you a Frigidaire Microwave Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...