Question about Minolta BIZHUBC351 Color Copier
Posted by Anonymous on
This code is not listed in the service manual for a C351. Could you have hit the wrong keys?
Posted on Jun 12, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
First check the alignment front and rear of the finisher, check the finisher exit guide rollers if the paper is exiting properly, open both rear and the front cover and check the lower gears attach is the up/down drive belt. that lower gear one might be broken by the pin slot.
Posted on Jul 09, 2009
2nd Drawer Lift-Up Motor Failure - The Lift-Up Sensor is not unblocked even after the set period of time has elapsed after the paper liftup operation for the drawer has begun.
Reset your Toners and Imaging units for Bizhub and CF series.
Posted on Nov 27, 2009
You have a problem with the fusing unit. This is the assembly that gets hot and "fuses" the toner onto your paper. This error code means that the fusing unit did not warm up properly. You will need to have a service company come out to diagnose and repair the problem then reset this code as service mode entry is required in order to reset. It could be as simple as cleaning the thermistor, replacing the thermistor, thermal fuse etc. I would estimate the cost at around $200.00.
Here is the section from the service manual that deals with this code:
Thermistor /1 (TH1) detects a low
temperature when a specified
period of time elapses after the
fusing heater lamp is turned ON
for the fusing ON control.
Posted on Jun 09, 2010
SOURCE: how to fix error c-1183
This code is for a bin/tray raising or lowering failure in the finisher. This can be caused by either the trays not being fully inserted into the finisher or something stropped the bins from raising or lowering. Check the trays and make sure they are as close to the finisher/fully installed as possible. Then turn off then back on the main power switch (NOT the stand by one on the control panel)
You should see the bins raising and lowering into their home position.
Posted on Aug 03, 2010
Tips for a great answer:
Mar 15, 2017 | Konica Minolta Office Equipment & Supplies
Apr 01, 2016 | Konica Minolta Office Equipment & Supplies
Nov 29, 2015 | Cars & Trucks
Feb 17, 2015 | Konica Minolta bizhub Office Equipment &...
Nov 14, 2014 | Konica Minolta bizhub Office Equipment &...
May 14, 2013 | Konica Minolta Bizhub C 353, Bizhub...
Sep 29, 2010 | Konica Minolta bizhub 180 All-In-One...
Nov 11, 2009 | Konica Minolta bizhub 350 All-In-One Laser...
68 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: