C2702 on bizhub 420 - Konica Minolta bizhub 420

SOLUTION: To clear the message:
1. Enter Service Mode.
2. Select [System 1].
3. Select [Initialization].
4. Select [Counter Data].
5. Select [Fixing Counter].
6. Press the Start button.
7. Exit the Service Mode.

C-1102 is a tray lift motor failure. Your copier is equipped with a FS-511 finisher. The trays on the left side (where the paper comes out) is being blocked when its trying to move up/down. Ensure the are no obstructions an restart your machine.

Have a tech come out admin password can change many things. should be done by a tech

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

print the meter count sheet

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Service manuals electronic components datasheets and equipment schematics...


try this site for a service manual did you clear the counters first????

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

4701=index sensor abnormality, turn off main switch turn back on.

malfunction was detected cs remote care c2403

Change the mechine speed .. 21 ppm

I had an older Minolta a couple of years ago. I'll try adapting what worked for it to this machine. Hopefully this will work.

Press the "utility" button. Then hit "admin settings". Enter a password of 12345678. Then hit "user authentication" and put in "off". Hit panel reset from the main menu.

Again, I'm not entirely sure this will work for the 420 but its worth a shot. Good luck!

konica minolta bizhub 420
error code 2801 plesce relese the code prectical met