Did you have the firmware (Copiers Operating system) NOT DRIVERS updated??????? Do this step
1. If it occurred after upgrading the Firmware,
conduct the following setting.
[Service Mode] ? [Sate Confirmation] ?
[Memory/HDD Adj.] ? [HDD Version Up]
If not do this:
2. Turn OFF the main power switch and turn it
ON again, and conduct the following setting.
[Service Mode] ? [System 1] ? [Initialization]
? [Data Clear].
IF not reformat the hard drive, or replace it.
Worse case replace the main board$$$$$$$$$$$$$$$$$$$$$$$$
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f
712 views
Usually answered in minutes!
×