Question about Kenmore 22422 Top Load Washer

1 Answer

Kenmore model# 110.26892690

Washer fills for the first wash & runs fine. but after the first draining it won't refill all it does is make a humming noise.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers
Re: kenmore model# 110.26892690

Sounds like the fill valve screens or fill hose screens need cleaning or replacing.Also if you are using burst resist hoses braided steel type some have check valves that if are defective may cause a no fill.

Posted on Oct 10, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Kenmore series 80 model 110 wont stop filling!

There is a clear plastic hose that runs from the load selection switch to the side of the washer drum. This hose connects the fill sensor to the load switch. without it being in good condition and connected properly the washer won,t get a signal that it's full.

May 09, 2013 | Kenmore Washing Machines

1 Answer

Kenmore washer 80 series stopped draining

So it will agitate and fill but the motor won't run during drain and spin?
If so, the likely cause is a bad lid switch. The paddle that the probe hits when the lid is down moves a small switch. That switch can do two things
1. fail internally. It will look fine outside but it won't close the circuit
2. the screw holes snap and it hangs off the wires, the probe no longer hits the paddle and the switch stays open.
The lid switch is cheap and very easy to repair.

Nov 10, 2011 | Kenmore Washing Machines

1 Answer

Kenmore topload washing machine that wont switch to drain

This assumes that you have a basic Kenmore / Whirlpool top load, direct drive, neutral drain (it doesn't spin until the pump removes most of the water) machine.

First, see the Sears parts site for your washer:

Enter your model number (###.#######) and you'll see a list of major sub-components with diagrams and parts.

Then, see the Whirlpool / Kenmore Service Manual for top load, direct drive washers.$FILE/L-55.pdf

Normally, this would appear to be a Lid Switch or Neutral Drain problem BUT since it is re-filling , it sounds like a Timer problem.

See the Service Manual for how to test / replace the timer.

Apr 16, 2010 | Kenmore Washing Machines

1 Answer

Will not drain or fill

just hit it with a hammer. thats what worked for my flat screen tv.

Sep 11, 2009 | Kenmore 43142 Front Load Washer

2 Answers

Kenmore Elite HE3 washer keeps filling with water

The inlet valve will need to be replaced. Its a fairly simple procedure and a pretty inexpensive part.

Nov 15, 2007 | Kenmore Elite 45986 Front Load Washer

Not finding what you are looking for?
Kenmore 22422 Top Load Washer Logo

Related Topics:

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Jesus  Colon
Jesus Colon

Level 1 Expert

12 Answers

Fred Sops

Level 2 Expert

271 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides