My windows NT windows office 200 laptop wont to connect to internet

Need first to install the program for that printer.

try to factory reset your linksays and then connect your device.

after connection of your device re configure your linksys again with 192.168.1.1 IP address

not that i think.Good Luck :D

First turn on your wi fi switch on laptop.
Then go to my netowkr places proeprty and make sure your wi fi network adapter driver is installed and enabled.
Then click on view available wi fi networks then check you get signal form wi fi router.Then it works.
Let me know if you need more assistanse.
Aslo you can check in router that wireles is enabled in router?
For that connect your wi fi router to computer with ethernet cable then you can access it with following link.
http://192.168.1.1
or
http://192.168.0.1
typoe user as "admin' and password as "admin" or blank or "password"
then check in wireless settings that it is enabled.

Thanks.

Try connecting to another wireless connection... if it connects to another connection and you get to the internet, then it is something with your wireless router or modem. Your PC can "see" a wireless connection, so it is NOT PC hardware.

It sounds like you can connect to the router, but cannot go through the router to get to the internet. Probably a simple issue with your modem or router. Try power cycling the modem, and power cycling the router. Then restart your PC and try connecting again.

If all that fails, try installing Mozilla Firefox and see if that will get out to the internet. It may be a problem with Internet Explorer.

dear,

Pl check with your modem wirless port is active or not samething in to your laptop and desktop.

after connection pl give your modem ip range and search for wirless device.

Regards,

Ravindra Shah

you wirless network might be protected by a WEP password which should be on the botom of the router

Uninstall the Belkin software and see if it helps. If not, then you will have to do a soft reinstall of the OS over the curent install with your Packard Bell Windows Cd, or a fresh install. (Make sure you make a back if you are doing a fresh install.

If you have made a restore point earlier, you can try to restore the system to a point before you installed the Belkin router. This way you do not need to do a fresh Windows install. But you will lose any data you stored since the time of that restore point.

Hi,

R u connecting through the wired connection or wireless connection ?