Question about Computers & Internet
Her in Canada if a similar problem existed the best way to get assistance is to have him live alone suddenly and then try to get assistance.
Posted on Nov 20, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You need to be connected using wired Ethernet (PC's LAN card to Router's Ethernet Port (at the back)). This is the preferable INITIAL way to configure the router before going wireless. Also it would be to your advantage to initially set your PC (that will be used for configuring the router) to "Specify an IP address" (static settings) and not "Obtain an IP address automatically."
For a PC connected via UTP networking cable attached to a Belkin F5D6130 AP, the networking settings could be:
IP Address 192.168.2.2
Subnet Mask 255.255.255.0
Default Gateway 19*126.96.36.199
DNS Server 192.168.2.1
Post back results. Good luck and kind regards.
Posted on Oct 12, 2007
have you check your phone line also go in to the admin settings and re put your username and password back in it should sort out as i've had the same problem if it don't work get back to me thanks
Posted on Mar 21, 2009
192.168.0.50 is the default address for your router, if router was boxed and new, this should be the router IP.
The router configuration must be done using a cable connection, cannot be done using wireless.
If you want to reset the router you can hold pressed the pinhole reset switch until the unit will restart, about ten seconds, this will reset IP to 192.168.0.50 . If router is irresponsive after reset and ethernet cable is tested and fine , then the router may be faulty.
You can call the phone number listed on the router manual to get online assistance.
If the router was not new, but had been re-programmed , the default IP may have been changed manually by the user, in this case do the following to find out the IP.
Click start button
Locate and use Run command
In the Run box type CMD, this will open command prompt.
in command prompt type: ipconfig /all
THe router Ip will be listed as 'Default Gateway'...192.168.......
You can also find IP by rightclicking on network connection, in Windows and choosing Status. ClThen clicking Support tab, and finding the default gateway IP address.
Posted on May 07, 2009
SOURCE: I'm trying to configure my
Network settings on your computer
right click on lan network and properties go to ipv4 properties and use the following.
IP address 192.168.1.2
router defaut in the default gateway settings (mine was 192.168.1.245)
enter that again in the dns primary (dont worry about the secondary)
plug an ethernet cable to your wireless router and type in the default gateway.
that will get you to your logon page.
hope that helps
Posted on Jan 11, 2011
Tips for a great answer:
Jan 23, 2017 | Computers & Internet
Nov 23, 2016 | Computers & Internet
Feb 18, 2015 | Computers & Internet
Dec 11, 2014 | Computers & Internet
Sep 08, 2014 | Computers & Internet
Aug 15, 2014 | Computers & Internet
Apr 15, 2011 | Toys
133 people viewed this question
Usually answered in minutes!