How do i replace the fuse on a jbl eon 515xt?

Sounds about right to me. I have 2 eon G-15s. If you don't hear any cracking sounds you should be ok.

I’m happy to help further over the phone at https://www.6ya.com/expert/phillip_293d34ebcf028794

*Always read the operators manual of any and all equipment you may acquire. We Engineers do it, you should too. I am sure it is in setup.
rockinbadboy-

Sounds like bad power supply capacitors

For some reason the soft on protection circuit has failed. it is not a simple fix and would require the amplifier module to be removed from the speaker to assess the damage.

Check fuse located inside and let me know the result to help further.

there could be something wrong with moisture. I had a drink spilled down the back of mine and I had to clean the board cause it kept blowing fuses.

Make sure you are driving this with a balanced input XLR or TRS type cable. The driving device should have the SAME type output...

If the fuse is blown, then there is a failure that requires servicing. Unless you are adept at electronics, take it to a repair shop. Here is your service manual:

http://elektrotanya.com/jbl_eon15g2_sm.pdf/download.html

Scroll down to "get manual" and click to download. IGNORE other download links.

The corrosion is probably due to humidity. The other issuses will requier it goes to the nearest JBL service center

Customer Service