Where are the batteries in evenflow ultra saucer

file:///C:/Users/erwooster/Downloads/25707060.pdf

States batteries are not replaceable, which means that they are buried somewhere inside the main module. Proceed at your own risk.

It starts from 3, 4, or 5 piece sets. lids and saucers are separate. 3 piece set will have a plate, cup, and saucer. 4 piece includes a salad plate and 5 pieces also include either a bread and butter plate or a soup bowl.
english dinnerware will usually have 7 pieces: dinner plate, salad plate, bread and butter plate, cup, saucer, soup bowl and stand.
The number of setting you buy depends on the number of people in your family or the number of people you plan to have in your family in the future. It also depends on how much entertaining you do.

I didn't find any direct information about evenflow beds. But they have some safety information that might be helpful. http://www.evenflo.com/

Who are the agents for Evenflow 12 volt pumps in sa.?

Use a saucer. You will need to put a small amount of warm water in a saucer, place the ink cartridges in the saucer, nozzles in the water. Leave for a few minutes. Use a paper towel to dab the nozzles dry. Once dry place the nozzle on a paper towel, you should see a Yellow, Magenta and Cyan colour wheel on the paper towel once you remove the cartridge. If not repeat the process until you do. Once you have the wheel visible all the nozzles are free of blockages and ready to use again.

https://plweb.evenflo.com/replacement_parts.aspx to enter your crib's model and date of manufacture for assembly instructions and limited parts replacement.
We do service Evenflo cribs also, should you need a part not available through the above website please call us at 800.205.9642 or 800.772.1041.

Brian, take nail polish remover and pour it into a saucer about the depth +- 2 to 3mm and leave it there till you notice the ink disolving into the solution, if that fails to work remove the cartridge and add boiling hot water about 5mm into a saucer, when you notice the ink flowing from the cartridge then remove it from the saucer, dry it properly and place it back into the printer. Then do a cleaning nozzle from the maintenance tab. Hope this helps, it helped me quite frequently

I am guessing the only solution would be to take the camera apart to get the ants out.  So, you would be best to take it to a repair shop and see what they think.

It is not a video game..it is a baby contraption (round with a cloth seat in the middle). It was the seat I removed and don't know how to get it back on..marien36