Where is the blower motor on 1992 dodge Dakota?

The problem was the motor. Replace the blower motor and resister and it should be fine.

If the blower motor resistor is experiencing repeated failure, the blower motor is likely drawing too much current. Excess current draw from the blower motor will cause the resistor to burn out. The blower motor in your truck has a resistor block with multiple resistor wires.
Jun 21, 2023

Why Does the Blower Motor Resistor in My Dodge Dakota ...

More here

https://www.google.com/search?q=2004+Dodge+Dakota.+It+keeps+blowing+the+blower+fan+resistor

..

blower motor resistor...it cuts power to lower settings...easy fix usually under passenger side glovebox two screws and harness looks like a metal card with plastic bottom...

should be just above the blower motor. You will need to remove the glove box door to gain access.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Maybe your blower motor is bad. It should blow a fuse though unless someone bypassed the fuse box or put to big of a fuse in it. You might also want to check and be sure that you have a good ground to the vehicle from the battery.

I had a 1992 Dakota

Is the blower not pretty much in the open, under the
dash where you can just unbolt it?

I will look in my factory manual if can't figure it out.

Roger it sounds like the blower motor is not comming on. There is a resistor network located in the engine compartment on the passenger side mounted to the firewall, that controlls the blower motor. The connections may have corroted or the unit itself is bad. That was the first thing I had to relpace when I got my used 92 Dakota. There is also a 30 amp fuse in the fuse box under the dash board . If that is blown I would suspect the blower motor is seized up or just pulling too much power.

Have you checked the blower motor resistor. Usually locate in the blower box with a plug on it. Has 2 bolts holding it in. Take out and inspect.

check the fuses then check the resistor to see if power goes there

is the blower motor coming on? check for power at the connector with the switch on

Check the connections at the blower resistor.