Solenold switch replacement on a troybilt mower

what are you trying to troubleshoot? heres the troybilt link to get you started

http://www.troybilt.com/equipment/troybilt/lawn-mowers/lawn-mowers?facet=cas_f9_ntk_cs%253A%2522Zero%2bTurn%2bTractor%2522&sortBy=3?cm_mmc=Google-_-Mowers-_-Zero%20Turn-_-Sponsored&gclid=CjwKEAjwi6OeBRCCrZqp-qaQhhISJACrfbtAq_Hepy9R8IgJYw_E9HkmY0pum-PDxyoqjOrFfOWq-hoCAknw_wcB

Check YouTube for a video

are you getting spark?is the fuel getting into the engine

try and jump start it with your car then check the safety switches if jumping doesn't help

try putting your serial number and model number here. http://www.troybilt.ca/troybilt/troybilt_manual_search.asp

Does the drive shaft going to the wheels turn at all?

If it doesnt you may have a unsecured pulley on the engine.

If the shaft does turn when you engage the tranny your next stop is taking the wheels off and checking the wheel clutches. Sometimes called sprag clutches. They are probably both stuck in the unlocked position. You need to clean them up by removing all the greasy material covering them and putting them back together with just a few drops of light oil.

I hope this helps. Good luck and be careful!

If you didn't by the Troybilt belt, try that. I had the same problem with a Napa belt. Going into drive as soon as I grabbed the operator presence button, not coming out of gear etc. When I switched the the Troybilt belt, the problem went away.

If it's the belt that just runs on the deck and not the one that goes to the engine, it is a 954-0349

Next thing to try would be the neutral safety switch located on the trans