Canon PIXMA printer - Model iP6310D - I get an error message: "The ink absorber is almost full. Press the printer's OK button to continue printing. Contact the service center.
WHAT SERVICE CENTER?
Try this: How to clear E27 Waste ink absorber full 1.With the printer powered off but connected to a power source, press the Power button while pressing and holding the Stop/ Reset button. 2. When the Power is lit, press the Stop/Reset button two times while pressing and holding the Power button. 3. When releasing the Power button and the Stop / Reset button (regardless of order), the printer will move into a service mode. (Waiting for menu selection) 4. When the on/off lights in green, press the Stop/Reset button the specified number of time(s) according to the function listed in the table below. (Each time the Stop/Reset button is pressed, the LED lights alternately in orange and green, starting with orange.) Note: press 4 times for waste ink counter reset. The number of the Reset button pressing LED Function Remarks 0 time Green Power off 1 time Orange Service pattern print 2 times Green EEPROM print 3 times Orange EEPROM reset 4 times Green Waste ink counter reset 5.Turn off the printer.( it must be turn off) then turn it on again If I could be of further assistance, let me know. If this helps or solves the issue, please rate it. Thanks, Joe
When I print a nozzle check the black at the top is missing and all the colors are faint. I have...
(More)
When I print a nozzle check the black at the top is missing and all the colors are faint. I have tried the cleaning 3 times and replaced a 1/2 full color cartridge with a new one. What's up?
cannot perform maintenance on the printer because the printer is not recognizing the correct...
(More)
cannot perform maintenance on the printer because the printer is not recognizing the correct cartridges that are in the printer.
I have a canon iP6310D printer that I am trying to install. Everytime I plug the in the power light...
(More)
I have a canon iP6310D printer that I am trying to install. Everytime I plug the in the power light and alarm buttons flash alternately. When I look in the manual for trouble shooting it says to call for tech support if this happens. Do you know a way around this or why it won't work?? Thanks, Karen