Brother MFC PLS OPEN COVER error message - Brother MFC 8820D All-In-One Laser Printer

hi

find link for brother printer error

https://help.brother-usa.com/app/answers/detail/a_id/67765/~/how-do-i-clear-the-message-cover-is-open%3F

contact me

If you want to reset your Brother MFC 9440N machine so you no longer have the error message: Toner End of Life, do the following:

1. Open the front cover of the 7820N, that is, the cover that allows you to pull out the toner and drum, but don't pull out the drum/toner.
2. Push the button: Options (located on the left of the control pad).
3. Type: *00 on the keypad.

The Brother MFC 9440N should be reset and the Toner End of Life message should disappear. Warning, this may void your warranty and ultimately damage your machine if you are reusing or refilling your cartridges, but you should already know that. Hope this helps.

I think the machine is telling you to look inside for a foreign object or scrap of paper:

1) Turn the machine OFF
2) Open the cover
3) Carefully inspect inside for a bit of torn paper, staple, paperclip or other such foreign object - gently clear any problem materials. Do not touch internal parts if possible. Use tweezers for small hard-to-grasp objects.
4) Close the cover, and power ON
5) If the MFC cannot reset itself, or if no foreign material is found, the machine should report an error code, for example "Machine Error XX"
6) From this code, brother support should be able to diagnose and help with your problem

remove and replace the drum unit, but leave the cover open. You should get the message "replace drum unit".....YES | NO? press "1" to reset. after it says "accepted", close cover.

Please rate me :)

gof **** yourself, where the hell do you show your suppoused solution !!! ???? !!!!

error 71 is a problem with the polygon motor which is in the laser unit. This error usually means that you would need the laser unit replaced.
I'd suggest calling out an engineer.

No solution, but I have the same problem. THe printer starts up fine, I hear no grinding noises or other "funny" nioses, and then displays no error message... UNTIL I ask it to print. Then I get a message that says, "Pls (please) Open Cover".

I open the cover and it says "Please Close Cover".

I close the cover and it says, "Please Open Cover"

and this happens forever!

Does anyone have any ideas? Can anyone help me?

Stefan

Pls open cover = Please open cover. Probaly has a jam - Open the cover remove the drum/toner unit and check for jammed piece of paper under of in the drum unit.

I had the same problem with mine. Lift the top scanner, and check the hinges on the left. That error message means that the little black sensor on the left next to the hinges is not meeting flat with the unit when closed. Hold the sensor in for a few seconds, and your printer will start working properly.