An expert who has achieved level 2 by getting 100 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert who has answered 500 questions.
Re: phillips 27 inch tv
Did you check remote like battry, loose nothing is deposited near battry contact etc.
if it is getting on from front board and not from remote then fault is due to remote.
but if does not start from front also then problem is inside tv.
like power supply or horizontal section failure.
please do not forget to check plug & socket.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Yes it is definitely time for a new tv. If you live near a populated area just go on your local craigslist and you can get great used televisions for quite cheap. I have seen nice 36" tv's sell for 50$ and less. Thank you and good luck, Lee
I can give you these. You should try them until one works hopefully. 0506, 0311, 0612, 0002, 0428, 0802, 0412, 0619. Sometime the universal remotes will not operate everything so be sure to try the power on/off and the volume and try changing channels before assuming the code is wrong. One of these should work...
Same Problem. TV was purchased from Sams Club about 2 or 3 years ago. workede great unti llast week. We were watching tv and it just shut off. The power button on the tv started to get soft were you had to push hard or just use the remote. My guess its something with the wsitch.
yesterday i was watching tv but suddenly it turned off and after that i was trying to turn it on but i wasn't.......but today it turned on , infact i was trying to turn it on.........i wanted to know what is the problem so pressed on botton and it said "FPA ON " after 10 min.again it turned off..............i don't know what should i do...........can you please solve my problem......i will be so nice of you.
Hey Jim, The high voltage protection circuit has gone out on the D-board and will need to be replaced. The fuse to the power supply is probably fine. A good repair tech shouldn't charge over $125 for this and it only takes a couple of hours. Let me know if I can be of further assistance.