Question about Maytag MAH6500 Neptune Front Loading Washer w/Built in Water Heater

1 Answer

Maytag neptune front loading washer

Shortly after we had this maching or within the 1st or 2nd year there was a loud baning noise during the spin cycle. also now timer does not complete complete wash cycle.?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 447 Answers

What is the model # of your machine???? The loud banging noise sounds like the loads were getting unbalanced. This is the most likely since i have no problems with the suspension all of a sudden not stabilizing tub properly. If the washer was moved or transported than that would make more sense to me. please provide as much info as you can. Try doing a load of 10 towels. Let me know how that does and with the model # i can help with pulling some diagnostic codes

Posted on Oct 07, 2007

  • joey  shearer
    joey shearer Oct 07, 2007

    ok got the model # sorry bout that didnt see it
    try the towels test and let me know if it finishes it. Does it do the banging noise every time or not just now it wont finish cycles??

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Noise during the spin cycle


You gonna have to pull it out and open it up and take a look see and a hear see inside the motor area. There is something hollering for help. Look fer it!

May 21, 2012 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

Maytag Neptune - MAH5500BWW makes loud, loud noise during spin cycle. What parts are necessary to repair the unit? I assume there are bearings and seals needed. Thank you.


Hi,
When my washer did that, I found that the shocks that hold the tub were bad...

Check out this tip I wrote about the noise and vibration that front loadwashers can make..

Washer Problems Washer noise when spinning
heatman101

May 26, 2011 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

Loud noises during spin cycles


Hello, If the noise is a squealing or grinding sound, you are likely looking at a bad seal and bearing.
If the noise is a knocking sound, it's more likely a suspension or out of balance condition.
Thanks

Jun 12, 2010 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

Maytag neptune


There is 2 possible problems. 1. Pump will make noise as soon as the drain and spin starts. 2. Rear bearing this noise usually starts later in cycle as the drum gets up to final speed. The rear bearing of coarse is the most expensive of the two as it is part of the outer tub.

Mar 04, 2010 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

Maytag neptune MAH14PDAAW speed control burn the IRF644


maytag fromt load mah14pdaaw during high speed spin loud noise. HOw to resolve are there any places to grease bearing?

Mar 01, 2010 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

Maytag Neptune front load washer model MAH3000AW, load during spin cycle


YOU MEAN LOUD DURING SPIN CYCLE? IF THAT SO, WHAT KIND OF NOISE? BANGING NOISE MEANS YOU HAVE UNBALANCED LOAD OR ONE OF THE SUSPENSION IS BAD OR FELL OFF. GRINDING NOISE MEANS YOU HAVE A BAD TUB BEARING, TO REPLACE THAT, YOU HAVE TO REPLACE THE WHOLE REAR TUB ASSEMBLY, VERY COSTLY. MEANS YOU PROBABLY BE BUYING A NEW WASHER.

BOYNISMO@YAHOO.COM OR 714-334-1998

Jan 14, 2010 | Maytag Washing Machines

1 Answer

Very loud noise during spin cycle


Probably a broken strut or support. some call it a shock absorber.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

May 17, 2009 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

Loud noise


Most noises from a washing machine occur during the spin cycle. If you hear loud thumping during the spin, the load of clothes may have become unbalanced. Stop the washer and redistribute the clothes, then re-start it. Repeat these steps if necessary

Hope it may help you;

Regards;
VOTIT

Jan 29, 2009 | Maytag Neptune MAH5500B Front Load Washer

Not finding what you are looking for?
Maytag MAH6500 Neptune Front Loading Washer w/Built in Water Heater Logo

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

Bill Long

Level 3 Expert

588 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

John Tripp
John Tripp

Level 3 Expert

4655 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...