Question about Dishwashers

1 Answer

Diswasher I am needing information on a GE diswasher, model GsD2600G00BB. The dishwasher will not drain after a cycle is finished. There are no obstacles obstructing the drain upon examination. Upon manual operation of the solenoid, the water drained properly. I would appreciate your input as to what the problem is and how to repair. Sincerely, Sonny Thacker

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 447 Answers
Re: Diswasher

You will have to test the solonoid electrically now its probably getting juice and the solonoid may have failed. You can get just the solonoid ot the entire pump assy for a little more.

Posted on Oct 03, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Zanussi diswasher ZDI6053N does not finish its cycle.It has to be turned off manually

Your dishwasher is a sophisticated device that registered most failures. The End of cycle LED flashes if there are alarms memorized. So, count how many times the End of cycle LED flashes.
For example:
One flash - i10, the problem with water intake
Two flashes - i20, a problem wit drain water
Three flashes - i30, activated anti-flooding device
..... and so on



Sep 01, 2014 | Zanussi Dishwashers

1 Answer

My asko 3122 dishwasher wont drain

It is likely that there is some minor clogging in the diswasher drain filter.Clean as per the user instructions available with the dishwasher. Also likely the kitchen drain could be clogging. Buy a dishwasher cleaning kit from supermarket. Finish make a good product. Use it to clean the dishwasher as per instructions on the kit.

Nov 27, 2012 | Asko Dishwashers

1 Answer

My diswasher will not drain, it seems to have completed the cycle but the basin is full of water when it finishes.

Dishwasher not draining issue usually occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dishwasher and remove the drain hose and check for any visible clogging. If still not visible then the drain filter or drain pump is clogged and you'll need to clean the drain filter and drain pump. Also, check for any food pieces stuck near the pump impeller.
Please note that dishwashers don't drain out the complete water such that heating element doesn't overheat. Hope this helps... Please post back for any further assistance.


Mar 25, 2011 | GE 24 in. GSD6200G Built-in Dishwasher

2 Answers

The clean light is blinking diswasher won't start

Push these buttons in this order High temp wash > Heated dry>High temp wash >Heated dry all the lights will come on and this will reset the board and run it through a short test cycle but more than likely it will come up again,It's a failure in the heating cycle either the heater itself or the turbidity sensor which sits mounted up into the tub right behind the drain pump...hope this helps

Sep 13, 2009 | Whirlpool GU2400XTP Built-in Dishwasher

2 Answers

Blocked drain message on GE GSD2800 dishwasher

pull the bottom tray out, in the back portion of the center of the dish washer there is a plastic screen looking thing, you will need to take a 1/4 inch nut driver and take out the screw pull off the cover and clean out the drain,, there is probly some food particals in there , it does havea small blade inside there to help sut up fine food that gets thru but it doesn't do it all the time ,, make sure you put the cover back on before runnig the unit

Jun 27, 2009 | GE Profile PDW8400J Built-in Dishwasher

1 Answer

Cleaning Cycle not Starting

Please provide the model number and the approximate age of the dishwasher.
If this diswasher uses a turning dial to select the cycle, which turns as the dishwasher progresses, I strongly suspect that this timer has failed and needs replacement. Especially since the soap door never opens. Does the dishwasher drain during and at the end of the full cycle?

Mar 29, 2009 | GE Dishwashers

1 Answer

Dishwasher will not drain water. Put Drain-O in did not work,ran short cycle water on floor. HELP

My Whirlpool Diswasher did not drain water. The same water has been recycling from washing thru rinsing and sitting there after done.
Model: S62NXPLP-7624

Oct 03, 2008 | Dishwashers

1 Answer

Diswasher drainage in an island


I suggest just putting a dedicated Drain in the island next to the Dishwasher. You can hide it in side the island. Under the house, tee into the Main Sewage drain.  You should not need to vent it as the sinks vent is near enough to keep you from worrying about that.   

Oct 31, 2007 | GE 24 in. GSD4000J Built-in Dishwasher

Not finding what you are looking for?
Dishwashers Logo

Related Topics:

593 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers


Level 3 Expert

4342 Answers

Are you a Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides