Question about Zebra Z4M Printer
I am using windows XP with an older printer on LPT1. I have loaded the newest driver and am using the Z4m Plus driver. The older ones do not seem to work. The printer prints fine just extremely slow. After each label it back feeds to start anither as if it was another job. whe you have hundereds of labels this is not good. It should continue with no pauses until the end of the job. Any ideas?
Send a code to the printer to eliminate the backfeed. Send it either via serial or parallel. Just put this line into a text file and copy it to lpt1: or what ever you have it hooked to. ^xa^zc2^xz^xa^jus^xz
Posted on May 12, 2008
You can change the backfeed option under the driver settings, I would also turn you print speed up too (on same tab) it sounds to be set on 2.5ips, crank it up to 7ips or higher
best of luck
Posted on Dec 07, 2007
Tips for a great answer:
Mar 23, 2010 | Zebra LP 2844 Thermal Printer
Nov 30, 2009 | Zebra Z4M Printer
Mar 30, 2009 | Zebra Z4M Printer
May 22, 2008 | Zebra Z4M Printer
669 people viewed this question
Usually answered in minutes!