Question about Peavey Speakers & Subwoofers
Hi I have a pair of peavey 115xt bins and I need some peavey satellite speakers, could you tell me what connections I need to make from the bass bins high output to the satellite tops is it 1+ 1- or 2+ 2- thanks.
SOURCE: Tweeters & Midrange Speakers
If you have a Ohm Meter, check the resistance to the speakers. If it is very high, the speakers are burned, (or the crossover is (just capacitors, and resisters...cheap)). If it is close to 4 ohms check the wiring and connectors..to and at the speakers, most likly the receiver/amp is not blown.
Posted on Apr 20, 2008
SOURCE: i have a pair of
what sort of amp are you driving these with?
is the amp set up with buit in x-overs?
check these settings?
Boxs should be configured already for full range from manufacture unless they have been altered since purchase,
Whats really funny is that your getting either tops or bottoms from them but not both at the same time......hmmmm
they are supposed to be full range cabinets,very good ones at that.
I suspect the amp is either faulty or x-overs are poked.
some times leads are a also the blame too.poor connections,etc.
if x-over is poked you will hear an ear peircing noise and a paper duding noise if the cones were gone,like a giant transistor radio with no bass and a very high pitched trebble burning a hole in your head,
Ok heres a cheap test,
Take the speakers to another amp and test them,
If same result then you know the answer
Let me know the results thanks
Posted on Jul 20, 2008
SOURCE: I have a pair of
you have one of two problems.1) the woofer is blown(most likely) or 2) the crossover is fried(rare). Take the woofer out and press on the speaker cone(softly). If there is a scratchy feeling when you move it or if it doesn't move at all, you'll either need a new woofer, or get that one reconed.
Posted on Dec 04, 2008
The bi-amp jacks bypass the internal crossover. You need to look at the crossover section and see if an internal protection fuse has blown or if hte crossover itself is smoked.
Posted on Mar 05, 2009
SOURCE: hooking up sound system
The RSQ player goes into the input section of the mixer.
The mixer effect send goes to the Quadraverb input and the output of the Quadraverb goes back to the effect in on the mixer. Now the Main out on the mixer goes to the EQ then the EQ goes to the compressor/limitor to power amp to speakers.
Posted on Jan 27, 2010
Tips for a great answer:
May 05, 2014 | Speakers & Subwoofers
Feb 01, 2011 | Mission 782 Main / Stereo Speaker
Dec 28, 2009 | Peavey TLS115X Speaker
Sep 10, 2009 | Speakers & Subwoofers
Aug 05, 2009 | Peavey PRO-12 (00497070) Main / Stereo...
Jun 07, 2009 | Peavey CH1 Speaker
Jun 06, 2009 | Speakers & Subwoofers
Mar 01, 2009 | Peavey CH1 Speaker
Aug 12, 2008 | Durabrand HT-3915 System
Jul 20, 2008 | Peavey CH1 Speaker
31 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: