Installing wireless G router

Don't you require an RJ-11 for a phone line, cause I don't see one on this model? In any case, the ATM protocol should be handled by the ISP modem, and the router should just pick up the established network over Ethernet.

Connect the ISP modem to main uplink port. Then connect pc to any other port. Done. Some models come with a setup disc, but not absolutely required.

http://homedownloads.cisco.com/downloads/userguide/E1000_V10_UG_USA_NC-WEB,0.pdf

Try removing power from the modem and router for 30 seconds, plug the modem back in first then the router. Also could be WPA, have you tried to take all security off and see if it makes a difference? Made sure the os is current with updates, some older sp for xp for instance had an issue with WPA.

Check All your connection Reset your Router in the back you will see a little hole with a button press on it for 10sec.. Then got in your Sitting Control Pannel add and Remove ...Remove your Belkin software and re start your PC then re install your belking software for Any PC You may have a 4 hub conection ... So make shure your Modem are connected on the right Hub on your Router and the phone line to the modem Because See The modem tranmit is data to the router the transmit on any pc connected ony your Router ...good luck

Hello emanuelav716, Your router does not need to be connected to a phone line. However is does need to be connected to a cable or DSL modem if you want internet access. If you are just looking for a network inside your home or business the router can be setup that way. Please reply with any other questions or rate this solution if you found it helpful. Thanks! Edward

you will need to set up the router manually.
First make sure that your computer is able to go online when connected to the motorola modem only.
Click Here for step by step solution

the router connects to the DSL / CABLE modem and NOT to a DSL filter.

If thats what has happened you could damage the router

you should connect as per the instructions that came with your router

eg.

Phone line > Modem > Router > Rest of network

Note there is no filter between the line and the modem !

filters are meant to go before phones and faxes etc not into a network
for more help

http://support.hubris.net/dsl/Self_Install_Instructions.pdf

http://windowshelp.microsoft.com/Windows/en-US/help/a7c73c9a-5bb6-4b3a-9a09-d9650c4ed51f1033.mspx#EMD

Hope this clears it up for you


If this information was useful please click

Not sure if I understand properly but your router should have a WAN port or an "Internet" port

your modem should be connected to it and your PC should be on any of the LAN port

you could try updating your router's firmware.. it fixes a number of bugs and makes the web interface multi-lingual. This version supports English, German, French and Spanish.

Try the Belkin WEB site or Google the driver

Please see my response to this question. Your university's connection is most probably a LAN connection, so you'd need to follow the instructions as if you had a cable internet connection (unlike DSL, a LAN connection and cable internet connection don't require authentication with the ISP).