RCA F27351WN I have a RCA F27351WN, and the picture looks like its pulling into the center, like a computer does, it is normal size in the center from left to right but widens as it goes to the top and bottom is there any way to fix this?? I dont have a manual for it as I just recieved it from a friend...

If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/
Line faults & possible causes to LCD & Plasma screen are given with illustrations. You can get an idea about the fault to an extent. Faults to all LCD & Plasma screen are similar, irrespective of its brand and screen size.

Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
http://electro-medical.blogspot.com/
http://electronicshelponline.blogspot.com/
In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.

Television Manual Search
Visit this site to download the manual.
http://electronicshelponline.blogspot.com/

Try by pressing "0, 0" by remote control. If it do not changes, there is no other way with select it by universal remote control.

The means the deflection is not working, there is a coil of wire around the neck of the tube, it is run by a transistor. This transistor has probably gone bad

Need an RCA remote, usually the up or down arrow, or maybe left or right. You can go into the menu and select picture size/format, select "full" or "panoramic"

Without the OEM remote you can't access that video menu to change this aspect ratio. Have you looked on eBay for an OEM?

Set all convergence controls to center and then manually set all tubes to as close as possible to coincide with each other. Then, use those electronic potentiometers to fine tune the picture.

this is the conversion chip or sometimes chips that cause these effects the chip or chips are about $30 each but labor is alot more $250 -$300