Harmony Profile washer

Yes unfortunately. but it's not terribly difficult to do. There are many how-to videos online

I assume you mean it sounds like a jet plane when it spins, if so, I suspect a bad tub bearing. Depending on age of the machine, probably too expensive to repair.

probably unbalance load inside, try to stop, move what's inside and restart, or maybe there is not enough inside and cannot balance ( one heavy item, add some item so it can balance them when spinning )

do u mean it leaves clothes wet?

May have a piece of cloth, plastic etc that may be stuck on something between the belt and the drive system, have a look underneath/back to see if anything is there.

you have described the noise from a front load washer in the spin cycle to a "T", it definately does sound like a jet engine. if it ain't broke...don't fix it!!

GE PROFILE HARMONY WASHER MODEL WPGT9350COPL WASHING CYCLE TAKING TO LONG

Hi there

Yea if the machine sounds like a train going through the middle of your house when its on spin it will most definately by your seals and bearings, an easy way to check is lean the machine back onto something and look underneath if the main seal is leaking and the bearings are run there will be rusty looking residue on the motor rotor(the round thing in the middle of the drum), seals and bearings are fairly expensive to replace About $350NZD if no shaft is needed and up to $500NZD if a replacement shaft is needed.

I hope this helps you out.

Nick

its your outer tub it has a hole in it

I have a maytag that sounds the same way but washes and spins fine despite all the noise???