The exact model is 41185. the "locked" light keeps blinking. Is there a reset sequence?

possible bad heating element

might need to run it through the cycle again. you may have disrupted the timers and if has not reset itself. try this link and see if these answers help you out.

Why does my oven light keep blinking after the self cleaning cycle on my...

the light may be flashing an error code which is identified by the number of blinks between a pause. If two pauses and two different numbers of blinks, it is a two digit fault code like a 26 or 42 as examples.

the control board is bad,replace it there is no sequence to rectify this problem the board is bad

Hi,
Cycling the power off and then on again will sometimes reset it...often you will have to call the customer service number to get the steps to take to unlock that...

Also check out this tip...

http://www.fixya.com/support/r3969401-self_cleaning_oven_problem

heatman101

F0 means no error. press cancel to clear display.
If you cannot then that key might be stuck, just a guess. I have your tech repair manual with failure codes and troubleshooting on page 43. This NOT a user guide. It is meant for qualified peeps. So be careful. Late model double oven tech repair manual HERE


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

http://b2b.frigidaire.com/support/manuals.asp
this is a free download site from frigedaire if you have your model number you can download your complete manuel i was unable to find the F9 code for an oven
but suspect it has to do with door lock switchs if you can download your manuel from site it may help you can try shutting off breaker for oven and see if it will reset
good luck ron

Try shutting off circuit breaker for a few minutes to let control module to power down, then turn breaker back on. This may reset the control board back to factory default and retract the lock servo. If this doesn't work then a service tech will be needed.

OK, this is not a good situation here. your Electronic Oven Control board is damaged. the logic sectors are faulty. The F-1 represents a major EOC failuer and, you will need to replace your EOC(clock) asap, if possible.

re-boot, I shut the breaker down for a few seconds and bingo, problem fixed