Question about Samsung HCM4215W 42" Rear Projection Television

2 Answers

Samsung HLP5063WX/XAA 50" DLP

Audio is fine, white screen with NO picture. All connections in place, lamp LED flashes as unit warms up, goes out once white screen appears.

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 148 Answers
Re: Samsung HLP5063WX/XAA 50" DLP

Here is a site for ColorWheel replacement, which is what you need to do if you hear that screeching or fan running noise coming from your TV. Sometimes the wheel just explodes which gives you no picture.

Posted on Jul 13, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer
Re: Samsung HLP5063WX/XAA 50" DLP

If you open up a small panel in the back of your TV, there is a little blue switch that you can see. You need to tie the switch down tight, and then start up the TV. It should work.
If it doen't work, press Mute>1>8>2>Power on your remote, go into debug mode, and then it might stop working.

Posted on Sep 20, 2009

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

TV lamp has been replaced, still won't come on, no picture. When turned on, I can see a blue, kind of sparking light and noise starts and does this about three times. TV powers down and does this again....

Samsung DLP TV Repair - No Picture - Replacing ...

? 2:41
Jun 11, 2012 - Uploaded by
DLP TV Repair No Picture Bad Lamp Bad Bulb TV Won't Turn On DIY Samsung DLP TV Repair How to replace Faulty LampTutorial Click Here to ... Rating is available when the video has been rented. ... is a replacement for the following DLP Rear Projection TV models: ... SAMSUNG HLR6167WX/XAA

Samsung DLP problems - Help! - > ... > Home Video Forum > Projection TV Forum
Oct 26, 2009 - I have attached a picture of to show where the "Light Tunnel" is located. Upload ... So now I have a Samsung HLN5065W/XAA that I am willing to part out or sell as is. ... I replaced the ballast but the TV still won't turn on. .... The lamp has been sitting on a shelf until two weeks ago, when the TV went dark. Samsung DLP Light Ballast
Apr 10, 2009
Archive through October 26, 2009 - Samsung DLP problems ...
Apr 8, 2009
Samsung DLP Flashing Standby light
Jul 1, 2006
More results from

Jan 19, 2016 | Samsung SELECT HLR6167WX/XAA Rear...

1 Answer

Why does my DLP TV turn itself off

Try replacing that lamp door switch, this has been known to cause issues in some Samsung DLPs

Contact Samsung at 1-800-627-4368 for proper part#

Oct 21, 2014 | Samsung HLP5063WX/XAA

1 Answer

Samsung DLP hlp5063wx/xaa - Cycles through the warm up 2 times but does not turn on, then 3 lights flash on the front (2 green, 1 red) Bulb is new and looks good, fans seem to be spinning freely. Any...

If your having the "3 light" problem it could be an indication of a bad lamp however if there is a buzzing or a grinding sound it could be one of two moving parts. The color wheel or the cooling fan. I would go the cheaper route and replace the color wheel first since you say the fan is spinning. The thing is the lamp will not turn on if there is a problem with one of the other two parts. The motor on the cooling fan is too small for such a big fan so I would definately try it next. It's a big problem with the DLP tvs. good luck!

Feb 14, 2011 | Samsung Projection Televisions

2 Answers

I have a Samsung HLR5067WAX/XAA 56 inch, rear projection. Replaced lamp on it two years ago, was working fine. This morning a sudden thunderstorm blew in. When the power came back on, the cable picture...

Hi,If your tv is a dlp you might be experimenting a color wheel problem.The color wheel is a rotating disc that has a gamma of colors it spins at high rpms.The light of the lamp goes through it to create the colors on your tv.When it starts to go bad you will get color distortion ,black and white picture and sometimes you will hear humming noises.Here's the instructions to replace it and your part # is BP96-01103A Have a bless one!

Apr 26, 2010 | Samsung HLR5067WX 50" Rear Projection HDTV

1 Answer

My samsung tv hlr5067wx/xaa screen turns black, sounds is fine. if i turn it off for awhile i can get picture for a few minutes, but it goes back to black screen

I suspect the lamp is failing on your TV. The lamp replacement code is listed on the side of the TV on a sticker that is orange and white. It will start with BP96-. The lamp code is crucial on these older Samsung DLP's because they used quite a few different styles. Please take a few moments to rate my answer. Thank you...

Nov 19, 2009 | Samsung HLR5067WX 50" Rear Projection HDTV

1 Answer

I have a Samsung DLP 50 inch tv, model #HLP5063wx xaa. A friend gave me the tv, and told me it wasn't working, probably needed a new lamp. When I try to power on the tv, it comes on but makes a terrible...

the lamp led will light when the color wheel is defective. If the noise you hear is a buzzing or screeching the color wheel is the most likely cause.

Sep 10, 2009 | Projection Televisions

Not finding what you are looking for?
Samsung HCM4215W 42" Rear Projection Television Logo

2,187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Projection Televisions Experts

Steven Wander
Steven Wander

Level 3 Expert

574 Answers

The Wyzzyrd

Level 2 Expert

83 Answers

Donald Griswold
Donald Griswold

Level 1 Expert

8 Answers

Are you a Samsung Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides