I moved the treadmill now it wont work - Sportcraft Exercise & Fitness

In almost all treadmill error 1 denotes the speed sensor error.
In you case I suspect there is some variation in the alignment of the speed sensor. May it moved away from the magnet Which is fixed on the rotating wheel. Try to make it closer as much as it can, be sure not to keep a small distance .hope it will solve the problem.
If you wish to get some more details about treadmill repair and service then check the following link.
http://electro-medical.blogspot.com/

Also there may be a problem with the LCB

1)LUBE THE DECK BELT, INMEDIATELY.
2) tES THE MOTOR INPUT VOLTAGE, IF THER ARE THE MOTOR NEED REPAIR.
3) tEST THE OUTPUT VOLTAGE BOARD, FOR INPUT VOLTAGE MOTOR, IF THERE ARE NOT THE BOARD IS FAULTY.

4) tRY TO RUN THE SOFTWARE CALIBRITATION.

SINCERELY.GOD BLESS YOU

I have the golds treadmill 410. It makes a unusual humming/grinding noise. When running on it it stops after about 2 minutes if that long. Any ideas?

Dear Sir:

Please go to this section:
http://www.spiritfitness.com/customerservice/video/treadmillvideos.html

see the videos for resolve the problem. Otherwise contact the support in the phone provided in this section.

sincerely. God bless you.

ernesto cuadra
managua, nicaragua. c.a

you need to check voltage going to the motors. no power ,the contoller board is not working. check the connections on the boardmake sure they are in all the way,also the power connections

the motor controller is shot and will need replaced.

I centered the belt on my tredmill and now it wont move at all. I tighted and loosened the belt. motor runs belt wont move

The manual said that after lubricating the deck, press Stop and Speed buttons together for 5 minutes and this will reset the lubrication message and the treadmill should work.

Check for a loose connection or a damaged wire. Pinched wires are common when machines are moved.