Question about Maytag Portable Air Conditioner M6P09S2A

Open Question

Squirrel cage on fan blower broke - Maytag Portable Air Conditioner M6P09S2A

Posted by Anonymous on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: Need to purchase new fan (blades only)

Part number for the fan blade is CRCFD5303-010

Posted on Aug 10, 2008

Ad
consumer45
  • 7 Answers

SOURCE: defective squirrel cage fan

Upon searching further, I found parts for the unit. www.appliancefactoryparts.com
Part CRCFD5303-010 Fan - $19.99
Part CRCFD3000-030 Motor - $49.99

Posted on Aug 15, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How remove squirrel cage for heater


usually unbolts from the firewall . maybe a squirrel stored some nuts in the cage

Apr 22, 2015 | Cars & Trucks

1 Answer

Troy bilt leaf blower won't blow


It sounds like the squirrel cage fan came off of the motor shaft or the motor shaft broke. You have to take it apart to know for sure.

Jul 25, 2014 | Garden

1 Answer

I have a New air 1400H and the blower fan has broke, can you tell me where to find replacement parts for this unit? I understand it has been discontinued for almost 5 years. Thanks for your help.Cont


You may have to remove the complete blower assembly, remove any dead squirrels, and take it around to various appliance parts suppliers to obtain a suitable replacement. You may need only a replacement motor if the squirrel cage is intact

Apr 30, 2013 | NewAir AC14000H Air Conditioner

1 Answer

Amana heat pump emergency heat comes on but blower will not start. The call for heat comes in and the heating element(s) glow red for a few seconds and then there is a "click" and the heating...


Check the blower motor capicator. It should be mounted close to the motor with 2 wires to it (brown,brown/white).
Turn the blower on the thermostat and spin the squirrel cage by hand and see if it runs after by itself. If it does then definitely the capicator is bad .If it still doesn't run then check to see if there is voltage going to motor.
If thermostat is calling for fan and there is voltage present at the motor terminal then the motor is bad

Jun 01, 2017 | Heating & Cooling

2 Answers

Why does my ac freeze up


Hello, air conditioners will freeze either due to low airflow.....such as dirty filter, dirty evaporator coil, weak or not running blower motor. Also, a low refrigerant charge can cause the unit to freeze up.

Jul 09, 2012 | Danby Heating & Cooling

1 Answer

Ac squirrel cage fan motor noise


Could be bearings going out, or a squirrel cage rubbing the blower housing, a squirrel cage blade that came loose, or a capacitor.

Jun 12, 2012 | Bryant Heating & Cooling

2 Answers

Hi, my 1998 dodge durango front AC/Heater blower motor run on and off, after the fan shuts down and stops running if I reah under the dash and hit the plastic fan housing it will start-up running but it...


If you can hit on the blower motor housing and the motor starts, your brushes on the motor are bad and the blower motor needs to be replaced. Used tested unit $30.00 at a junkyard. New rebuild $54.00.

Many posts have stated that the dash must be removed to replace the blower motor. It can be done without removing the dash. I know as I replaced the blower motor on my kids 99 Durango last night but it took about 4 hours. Now that I know how to do it, it would estimate 2 hours.

Remove glove box by opening glove box all the way. Press inward on the both sides of the glove box to allow the rubber stops to clear the catches and lower the box The two outer hinges (plastic) will come off by slightly twisting the glove box upward leaving only the center hinge (plastic) in place. Reach in and push down on the hinge to pull out glove box. Set aside.

Remove side trim panel by pulling back carpet and remove one Phillips screw. Remove panel by pulling back on upper portion to remove clip from frame, then slide forward to remove from lower plastic trim.

Use 1/4" nut driver or socket to remove two screws holding vacuum canister on lower right side of blower shroud. Remove two vacuum hoses noting which hose goes to which side of the vacuum canister (both were green in color on my Durango). Disconnect connecting rod from vacuum canister to vent control by removing lock washer (you may be able to get away with not removing the rod, but the plastic "fin" may break if you stress it while removing the blower shroud.

Use 5/16 nut drivers/sockets with extensions to remove the blower shroud hex bolts. The hex bolts are located in several areas around the shroud (use your finger to follow shroud edges to locate all 8). Some of the hex bolts are very tricky and may require odd positioning of your body to locate and remove them.. I also put several extensions to use in order to reach the various hex bolts. Once the hex bolts are removed, pull the plastic blower shroud down exposing the blower motor squirrel cage.

Remove two of three hex nuts holding blower motor in place. Loosen the third one and the blower motor should come free. I was not able to remove the squirrel cage from the old motor so I broke the squirrel cage allowing me to expose the wire harness and grommet that went through the back of the shroud.

Feeding the wire harness back through the assembled wall appeared to be a real challenge, so I cut the green and black wires at the motor for splicing into the new motor later. Remove the motor and broken squirrel cage and throw the dam thing away.

Remove squirrel cage from new motor by removing retention clip with a pliers. Pull off the squirrel cage carefully by applying WD40 (or other lubricant) to the shaft. You may have to place two large screw drivers or other pry bars underneath the squirrel cage equally across the underside of the squirrel cage slowly prying up the cage. I accomplished this with a helper to hold the motor in place to allow equal pressure from both pry bars.

Cut green and black wires on new motor leaving enough wire to work in the tight area of the motor housing. Strip wires from old harness and new motor and apply **** splices for green to green and black to black. Add electrical tape for extra mechanical strength and insulation.

Place new motor into housing and secure the three mounting hex nuts. Turn on key and run blower to make sure it works. Install squirrel cage and retaining clip on motor shaft. Run again to make sure it works.

Install the balance of the items in the reverse order you removed them.

Good luck!

Now on to replace the rear wiper motor on the same Durango. Junkyard parts $54.00. Time: Unknown?

Jul 31, 2011 | 1999 Dodge Durango

1 Answer

The fan on this AC broke for some reason. The blades flew out of the AC. Can this be fixed? If so, how? How much for new fan?


outdoor fan if it hit your condenser coil your toast, if its indoor blower (squirrel cage) lets say about $500- $700 if you have pro do your work. have a pro do it NATE certified

May 23, 2009 | Heating & Cooling

1 Answer

Mod ASU24C1


If the blower is made of plastic it does not have a set screw. You most likely need a new squirrel cage. They are formed to the shaft and have a compression ring that holds them in place.

May 28, 2008 | Fujitsu 24C1 Air Conditioner

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Heating & Cooling Experts

Cindy Wells

Level 3 Expert

5161 Answers

Bill Long

Level 3 Expert

587 Answers

Donni Steen

Level 3 Expert

659 Answers

Are you a Maytag Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...