Question about Cobra Radio Communications
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Repair of Mic
Sounds as thought you have a bad element. You can order another element from Asatic or your local CB shop should be able to help. Good Luck
Posted on Jan 07, 2008
You don't mention if the Madison is a 4 pin or 5 pin also you don't mention if the D104 is a 4 wire or a 6 wire microphone so this will be rather lengthly of an answer so if I help you could you atleast do the rating for me ? So here goes 4 pin / 4 wire 1]SHIELD 2] WHITE 3] RED 4] BLACK....O.K. 4 pin 6 wire 1]SHIELD & BLUE 2] WHITE 3] RED 4] BLACK YELLOW NO CONNECTION.....Are you with me so far ? Half over 5 pin 4 wire 1] WHITE 2]SHIELD 3] BLACK 4]N/C 5] RED.....5 pin 6 wire 1] WHITE 2] SHIELD&BLUE 3] BLACK 4]N/C 5] RED.I hope this helps you GOOD LUCK and have a good day Dan.
Posted on Jul 12, 2009
Testimonial: "THANKS ALOT IT WAS VERRY HELP FULL"
There should have been instructions that came with your reverb board. You are going to need to drill another hole in the case of the radio, or find a control where you can install a dual control knob onto.
Your reverb board is likely going to need 8v, so you will need to locate that off the logic board, likely from the frequency synthesizer. The the audio lines from the mic, or the output of mic amp, are going to be redirected to the reverb, and the output of the reverb feed back to where the wires were removed from.
If I recall correctly, the 148 is a bit of a bear to work with, not much room inside. You will likely have to get creative in placement of the reverb board itself. Make sure to wrap well so that it doesn't get tossed around and break something inside.
Posted on Sep 15, 2009
Tips for a great answer:
Mar 13, 2016 | Radio Communications
Jul 10, 2014 | Astatic D104 T - Ug8 Crystal Microphone...
Oct 23, 2012 | Astatic D-104 Mic Microphone With Stand...
Aug 31, 2012 | Astatic D104M6B/4B Model D104 Amplified...
Apr 18, 2011 | Astatic D104M6B Consumer Microphone
Feb 05, 2010 | Astatic 636L Noise Canceling Microphone...
Nov 17, 2009 | Cobra 25 LTD 40-Channels Base CB Radio
Nov 02, 2008 | Astatic 636L Noise Canceling Microphone...
118 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: