Question about Amana AOCS3040SS Electric Single Oven

Open Question

Have an Amana Halogen Plus Counterrange. Have break in present range top and need to know where to purchase a new one.

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to test amana bake igniter


bad control board if ignitor works on broiler

Jan 24, 2013 | Amana AOGD2750 Gas Double Oven

1 Answer

I HAVE A AMANA SINGLE WALL OVEN THE ELEMENT SPARKED AT THE BACK OF THE WALL. I PURCHASED A NEWW ELEMENT AND WHENITOOK THE OLD ONE OUT THERE WAS NO WIRE TERMINALS AT THE ENDS OF THE PLUG IN END OF THE...


when it burnt off it fell somewhere between the oven chamber and the back panel.once finding it,its just a matter of splicing a new wire terminal end and attaching it to the element. The problem lies in thats its a built in wall oven and may be needed to be removed from the cabinet to find and repair this wire. Depending how tight it fits into the cabinet it may not come out easily and even break the wood around the cabinet. which of course you could face in pulling it out to replace it with a new oven. ONe thing to keep in mind is that all wall ovens are slightly different in size and the replacement oven needs to be pretty close to the size of existing one or the cabinet will need to cut or filled in so their wont be a gap left when new one is smaller leaving a gap in cabinet up to 2 inches on either top or side walls

Aug 13, 2011 | Amana Ovens

1 Answer

Hi there. there is no spark to ignite the gas in oven.


You will need to replace the spark module if you don't hear any clicking, or there is no spark present when trying to ignite the gas.

To test the Spark Module:
When properly operating, the spark module repeatedly produces a spark at the ignitor accompanied by a sharp snapping sound.
  1. Turn off gas and power supply to unit.
  2. Check wiring diagram to verify all terminals and wire connections are correct and tight with no cuts in the wiring.
  3. Prepare to measure voltage on spark module from terminal L to N.
  4. Turn power supply back on.
  5. Turn top burner to LITE position.
  6. If no voltage is present on the meter, this will indicate the electrical circuit is interrupted before the spark module
  7. If voltage is present, then check ignitor.
  8. If ignitors are ok; then replace spark module.
To access the Spark Module:
  1. Turn off electrical power and gas to the range.
  2. Disconnect gas and power from unit.
  3. Remove screws securing top surface burners.
  4. Remove surface burner and disconnect spark ignitor wire from surface burner.
  5. Raise and remove maintop from unit.
  6. Remove screws securing spark module bracket.
  7. Disconnect wire terminals from spark module.
  8. Replace and reassemble in reverse order.

May 18, 2011 | Amana Ovens

1 Answer

My GE oven isn't lighting but the electrics work...What should I do? Please help


Bulb required: Manufactured by Aglaia for GE, 130V 35W Halogen bulb

There is a grille above the door and clock/cooking controls that extends the width of the unit. You need to remove this to get to the light receptacle. With the power to the unit off (unplug if you have access to it), get on a chair with a Phillips head screwdriver. Look down from the top and you will see two screws about 6" in from the ends. If you don't see the screws, open the cabinet doors above the unit (mine were blocking the screw heads). Remove the screws and set aside. Pull girlle towards you at the top being careful not to break the tabs at the position where the screws you just removed are located. After the tabs are out the grille should lift up (there are three hook-tabs along the bottom). Set it aside. Over toward the right you will see a smaller vertical grille. Just to the left of this there is a void with a Phillips head screw facing you. Remove the screw from the receptacle tab. Lift up the receptacle tab on the right. When the receptacle is clear on the right, move the receptacle to the right to release it from the tabs on the left. Lift the receptacle up until it clears the housing it just came from. Pull it gently toward you, rotate it bottom-toward you, and you will see the bulb to be replaced. My bulb was lightly held in using white silicone and removed easily by pulling it in the direction it was pointing. A word of caution about Halogen bulbs: When handling new bulbs be careful not to get any grease on them and handle them with clean cotton gloves or a clean t-shirt. Grease and oils from even clean hands will cause the bulb to burn out quickly. Replace the receptacle being careful to make sure the electrical wires are not pinched by the receptacle housing. Replace the screw; replace the grille; return power to the unit. You're done!

Lamp Halogen ranging in price from $8.10 to $10.71.

Jan 05, 2011 | GE Profile JTP18 Electric Single Oven

1 Answer

On a Amana EvenAir convection Plus oven the convection blower comes on during the regular bake cycle.


There is a blower on the top of the oven, which turns on when the oven is hot enough. If the warm/hot air is coming out from top vent corners - this is the blower working. Even if you turn the oven off at that moment, the blower will still work until the oven cools down. This is normal.

Oct 12, 2009 | Amana AOCS3040 Electric Single Oven

1 Answer

How to remove timing control panel on Gas Amana Range AGS746E


Here is a diagram of your stove console. Make sure you remove the nuts holding the switches to the console.
7c9e828.png

Feb 25, 2009 | Ovens

1 Answer

Halogen ring not working


Hi .
It sounds like the temp control is faulty.
Either way you are going to have to remove the hob top to access the controls and elements, Then you can check if the element is getting a feed to it.

Sometimes you can see if the element has gone, .

If you need any further help, let me know.Good luck.

Nov 23, 2008 | Ovens

1 Answer

Gas Range Oven use without electrical power


It will be necessary to change the top burner orifices when converting to propane. You should be able to light the top burners with a match or lighter, however, the oven will need proper operating voltage.

May 22, 2008 | Amana Ovens

Not finding what you are looking for?
Amana AOCS3040SS Electric Single Oven Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Amana Ovens Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Sal DeAngelo

Level 3 Expert

2333 Answers

Ismael Rodriguez...

Level 2 Expert

171 Answers

Are you an Amana Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...