- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Error 5110 means Carriage lift mechanism error. This is a Canon-specific error code for its printers. Aside from this error, usually there's a sequence of alternate blinking in orange and green of the LED light(alternating cycle of green and orange lights x 11)
Its one of the Service Call Errors which means a part of the printer is missing or broken, and needs to replaced or repaired by a Canon Authorized technician.
Solution (Replacement of listed parts, which are likely to be faulty): - PR lift shaft - Sheet feed unit - Logic board - Carriage lift sensor unit Disclaimer:Things you can do if you know how to work with printers(Advanced), if this printer is under warranty and/or this will be the first time that you're gonna work/ troubleshoot this printer and/or you definitely have a hard time understanding these terms I've mentioned better call an Authorized Canon printer technician
If you know a lot about printers you can take the printer apart and see whether you can cycle/roll the wheels at the purge unit and the greater wheel which lifts the carriage unit freely. These wheels are behind the main board at the right side, so you have to dismount all the cables and the main board with its cage at the bottom screws.
there is a rubber blade similar to the wipers on your car, that clean the drum. when there is an obstruction under the blade it does not clean that area around the drum leaving that line. i would say a technician needs to be contacted.
this happens during automatic color calibration, more than likely you need new color developer installed by a technician. turn machine on holding the 0&8 buttons to enter service mode type 4546 and 0 then start and 556 and 0 (start) 557 and 0 (start), then hold interrupt it will beep 5 times and shut down, this will turn off the calibration and allow you to make copies but will not improve quality.
Error C57 is a Communication error between main unit and IPC board. There are a number of things that could cause this problem from the fuser to an add-on. It could always be the board itself. You should have a service tech. come out and look at the machine for this problem. Having someone look at the machine would be cheaper then to just start replacing items/ units.
The F1-06 error is = Paper exit drive overloaded in sorter. This means that the exit unit is not driving/ turning properly/ fast enough. This could be that the motor is going bad, exit sensor is bad, drive belt is bad, paper or forgn. ( staple, paperclip, .ect...) in stuck in that area. If you do not have the proper wall voltage, could cause this problem.
Check wall voltage, check exit area for torn paper, paper clip, etc..., check exit sensor and actuator, check belt for wear or broken, check motor ( is it turning/ running) and then controller brd.