Question about Stanley Hardware 730610 110 Lb Garage Door Extension Springs

1 Answer

My garage door will not open but approx. 8" , no cable broken , chain on track. Today I found that one spring is broken. how hard is it to replace.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,113 Answers

I have built many garage doors and installed many door openers. The typical garage door spring is not that hard to replace. I have to have 2 steel rods 1/2 inch in diameter to slowly tighten the spring.

Posted on Oct 18, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Cannot open my garage door manually after I disengage it from the garage door opener (chain drive)


They are not light weight but there is no reason if the motor can raise it, then you cannot raise it by hand.

Feb 05, 2016 | liftmaster chamberlain 1/2 hp chain drive...

2 Answers

My Sears 3/4 HP garage door opener opens the door about 1', then will not go past this point. It will close it as well. I have taken the door off the chain and the chain will run without the door...


1. disconnect the door from the chain. 2. inspect the door again, try oiling the rollers and joints. It is the chain that lifts the door. Try manually lifting the door. If it still does not lift open, it is the door and not the Opener unit. 3. Although you don't see kinks, look for any obstructions eg. the track. 4. Make sure the track has not lossened out at any point. 5 If you can lift the door,. connect with the chain. Goog luck. Basically I think it is the door mechanism that has some how misalligned.

Jul 05, 2014 | Sears Craftsman LiftMaster Chamberlain...

1 Answer

Liftmaster troubleshooting


open your garage door , when the door is going up block with your hand one sensor eye , if your door going down ,you have inverted down-up cycle if not mother board is damaged youll need remplaced

Oct 17, 2013 | Building Materials

2 Answers

I have a Sears Crafstman Garage door wireless opener. Model 139.53615SR . The door hums but nothing happens. The chain doesn't move. The springs on the door broke last year and i replaced both of them....


My plastic gear stripped soon after a spring broke. I think the broken spring put a huge load on the opener that day and ruined the gear. Replacement wasn't too hard. It will be obvious when you remove the cover if the gear is stripped. Here are instructions:
http://tinyurl.com/gearfix
dwdfixya_1.jpg

Dec 19, 2010 | Sears Craftsman LiftMaster Chamberlain...

1 Answer

Garage door does not open. goes up about 4 inches. disconnected from opener and still can't open. checked wheels in frame move by hand. opener works when not attached to door.


You probably have a broken torsion spring. If you have a spring on a shaft above the door (usually 2 if it is a double door) then you have a torsion spring. From this shaft you have a 2 cables wound on a drum going down to the bottom of the door. If it is a single door, then this cable will be loose. If you have a double door, then most likely one spring is broken. This allows the door to open slightly, until one side is trying to lift(good spring) and the other side cannot (broken spring) Unless you are an EXTREMELY CONFIDENT DIYer then you should leave this do a door repairman as winding a torsion spring is dangerous, and can break bones or even kill. Now if your door has extension springs on each side of the track,with a pully and cable, then these can easily be replaced yourself. Check that cables are connected to the springs and the door and that one didn't break or come loose or cable off pully and binding.

Oct 21, 2010 | Garden

2 Answers

My garage door opens about a foot and then stops suddenly and doesn't move. No blinking lights start, so I am not sure what is going on. I also don't have my user manual to help me out. Chain looks...


check the track system to make sure all the wheels are in track and/or there are no obstructions preventing it from opening, it may be equipped with an emergency shut off if there are any obstructions, also, make sure track is well greased, too dry of a track causes alot of friction.

check with your model number on chaimberlain's manual download page here:

http://www.chamberlain-diy.com/doityourself/support/manuals

Oct 17, 2010 | Chamberlain 12HP Power Drive Chain Drive...

1 Answer

Lift master Garage doors the door doesn't close. once i press the button to close my garage door it shuts the door momentarily and then it opens right back up by itself. nothing is blocking the sensors.


Too much tension on the door can make the "brain" respond by opening the door, thinks something is in the way.... check for binding tracks or wheel guides, loose bolts, dry chain, tension on cables or springs ( be careful here), misaligned sensors....

Apr 06, 2010 | liftmaster Chamberlain Garage Door Opener...

1 Answer

Liftmaster Professional Line 1.5 hp won't open the garage door


Sounds like a bad spring or the drive gear is going bad. Take a good look at the springs above the door. It is sometimes hard to tell when one is broken. Remove the cover and look at the gear. It is obvious when this is going bad.

Aug 03, 2009 | Sears Craftsman LiftMaster Chamberlain...

1 Answer

Garage door spring broke and need to get the car out unti repaire


pull the rope attached to the garage door opener.  And get a friend to help you lift the door.

Mar 15, 2009 | Sears Craftsman LiftMaster Chamberlain...

Not finding what you are looking for?
Stanley Hardware 730610 110 Lb Garage Door Extension Springs Logo

398 people viewed this question

Ask a Question

Usually answered in minutes!

Top Stanley Hardware & Accessories Experts

Gene Haynes

Level 3 Expert

5089 Answers

Tom Chichester

Level 3 Expert

33294 Answers

Are you a Stanley Hardware and Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...