Error 6502 - Canon PIXMA iP3600 Photo Printer

Dear kindly reset the printer to its factory default setting.

The error 6502 is an "Ink tank position sensor error". It may be that the sensor is dirty and needs cleaning. Make sure you haven't got any bright lights shining into the printer.

Error 6502 (Ink tank position sensor error) the sensor is receiving too much light. Possible causes are:
1. The printer cover is open and the sensor is exposed to the light
2. The ink tank LEDs are busted
3. Sensor or its wire connection to the logic board is busted or disconnected

Solution:
1. Close the printer cover
2. Possible ink tank replacement
3. Change sensor or repair disconnected wires

ok
Try
Error Code 6502 appears generally after chaging a cartridge.

Solution:

1. Unplug the printer.
2. Remove the faulty Cartridge
3. Plug in the printer and press and hold power button
4. Keep it held down. Press Resume twice, and this should reset the fault.

All Best: Pineworks

Error Code 6502 appears generally after chaging a cartridge.

Solution:

1. Unplug the printer.
2. Remove the faulty Cartridge
3. Plug in the printer and press and hold power button
4. Keep it held down. Press Resume twice, and this should reset the fault.

All Best: Pineworks

canon pixma 4500 service error 6502

Try cleaning the print heads with the Canon software.

This might work
Error Code 6502 appears generally after chaging a cartridge.

Solution:

1. Unplug the printer.
2. Remove the faulty Cartridge
3. Plug in the printer and press and hold power button
4. Keep it held down. Press Resume twice, and this should reset the fault.

All Best: Pineworks

Click the link for Cannon:
http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&fcategoryid=116&modelid=13800#SupportDetailAct
Under Please enter your question:
Type in error code 6502 Click Search
Click number 1
ERROR LCD: Error code (5xxx through 9xxx) appears on the display