Question about Trijicon Optics

Open Question

Lee enfield rifle #1 mk3 with trijicon acog can it be done?

Posted by Anonymous on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 44 Answers

SOURCE: ive got an 4x32 acog and the elevation is knob

Jonny,
If you've mounted the firearm in a shooting vise and can still verify it isn't moving there's not much to do but send it back to trijicon. If it's less than 30 days old you could take it back where you purchased it and they would most likely exchange it as defective.

hope this helps, Mark the Gunsmith
*Please give feedback on this answer*

Posted on Dec 30, 2009

Ad
  • 9 Answers

SOURCE: I'd like to find an owner's manual for a TA01NSN:

again go on line with trijicon and go to tech support. there is most always a phone Number that you may call to talk to some one.

Posted on Apr 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Lee enfield parts action


http://www.ssporters.com/british-enfield-s/134.htm

May 11, 2017 | Osprey The Lee-Enfield Rifle

1 Answer

Rifle parts


Basically, it's a Lee-Enfield No. 4 action, converted to a target rifle by Parker-Hale.

So depending on what parts you're looking for, some of the standard Lee-Enfield No. 4 should work.

Aug 12, 2014 | Optics

1 Answer

I wish to know the difference in the different 303's. I purchased a Lee Enfield approximately 50 years ago. I now must replace the stock and thought a synthetic would be the way to go. It has a squre bolt...


Hello Julien Mirault,

The whole point of a MILITARY MODEL ...
is for PARTS interchangeability... AMONG the
estimated 17 million produced... (Not rare).

To tell precisely which of the "303" models
you might have... you need
only read about the models below...
LeeEnfield Wikipedia

Three main characteristics (From 1895 to 1962)
- REAR Sight position & windage
- Clip FEEDING brace atop/rear of chamber
- Magazine capacity


Check at the Wiki article (above)...
or FEEDING "stripper clip" below...
Stripper clip Wikipedia

Searching on
the internet... once you have typed in "Enfield 303"
The only remaining concern you ought be
confronted with... is what "STYLE" synthetic
STOCK you will want... (personally I love the wood

My best advice would be to pay attention to
characteristics that would reduce the KICK
(pretty powerful) back of this rifle when fired.

Condition: That is truly a shame...
but AS the markings are mostly lost that means
the finish is likely also been worn away...
So from a "collectible" standpoint there is no
probable significance... (unless historic

The Lee Enfield "303" highly recognizable by
the very long barrel and FULL wood stock...

The 303 strikes a beautiful profile when converted
as a "hunting rifle" ... (like: Monte Carlo STOCK)
ATI 303 308 Enfield 1 Mk 3 Monte Carlo Stock

Parts are available everywhere (including AMAZON)
ENFIELD 303 RIFLE TOOL SET WITH 1 THREE POCKET POUCH AND 6 TOOLS CAL 303...

Hope this helps

Carnac the Magnificent

Aug 27, 2017 | Military Collectibles British Enfield...

1 Answer

How to increase power to my daystate mk3 air rifle


Get a new air rifle with more power?

Dec 29, 2013 | Optics

1 Answer

How to change the batteries on my bsa tactical stealth acog


The large knob on top holds the battery. Should be a slot that a coin will fit in to remove the cover.

Aug 19, 2011 | BSA 30mm Stealth Tactical Rifle Scope with...

1 Answer

The reticle on my ACOG 3.5x scope won't go down far enough sight in @ 100yds. It is 12" high at 100yds and the reticle is maxed out. What should I do?


this is not uncomon jack up the frount of the scope with a fuw strips of 35mm film if you can this will lower the point of aim a lot at 100yds,,,you may need to let off the screws and fit a thin washer/s under the scope to lift the frount up

Nov 20, 2010 | Trijicon ACOG Rifle Scope 4X 32 Matte...

1 Answer

Ive got an 4x32 acog and the elevation is knob isnt changing the placement of the reticle, is there any way to fix without senging back to trijicon


Jonny,
If you've mounted the firearm in a shooting vise and can still verify it isn't moving there's not much to do but send it back to trijicon. If it's less than 30 days old you could take it back where you purchased it and they would most likely exchange it as defective.

hope this helps, Mark the Gunsmith
*Please give feedback on this answer*

Dec 28, 2009 | Trijicon Optics

1 Answer

Wont go to right far enough


you may have to add an shim on the corsponding part to rectify the issue. or if it is overwhelming take it to a gunmithing

Dec 24, 2009 | Trijicon ACOG Rifle Scope 4X 32 Matte...

1 Answer

I'd like to find an owner's manual for a TA01NSN: 4x32 Trijicon ACOG® with Yellow Center Illumination. My email is mmcglashen@msn.com An on line manual would be fine. thanks in advance, Michael


again go on line with trijicon and go to tech support. there is most always a phone Number that you may call to talk to some one.

Jul 13, 2009 | Optics

1 Answer

LOST MY MANUAL FOR MY TRIJICON TA01NSN SCOPE


Done it before, calling or emailing Trijicon directly will solve your problem.

Mar 14, 2009 | Trijicon ACOG ECOS Rifle Scope 4X 32 Amber...

Not finding what you are looking for?
Optics Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Trijicon Optics Experts

Joe Lalumia aka...
Joe Lalumia aka...

Level 3 Expert

3186 Answers

yadayada
yadayada

Level 3 Expert

79847 Answers

james laughton
james laughton

Level 3 Expert

2191 Answers

Are you a Trijicon Optic Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...