Question about Sewing Machines
Your thread tension wheel may be set to too high of a tension, which will cause the thread to pull out from the bobbin. Try a lower tension setting.
If set too low, then threat from the top end would hang loose and possibly snag, instead.
Posted on Oct 14, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: thread wont overlock
When the thread breaks too often, try these, that goes for all sewing machines
1. Replace the needles,
2. Loosen slightly the tension of the needle threads.
3. The top threads are to thin,
4.The sewing (rotary) hook or looper, has burs,
5. Wrong threading
Posted on May 28, 2008
Check there is no thread caught in the tension units and set them ALL to 3 for the Factory setting......try a sample.....if it looks good, OK, if not, try to balance it by gently altering the knobs on the right (loopers) until they form an even tension in balance with each side of the fabric.
Posted on May 31, 2009
Tips for a great answer:
Jun 10, 2010 | Janome MyLock 634D Mechanical Sewing...
Jan 01, 2010 | Janome Sewing Machines
Nov 23, 2009 | Janome MyLock 634D Mechanical Sewing...
May 24, 2009 | Janome MyLock 644D
34 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: