Thermador dishwasher dwhd64ep/48 will not drain

My Thermador Dishwasher is displaying an error code E24, what does it mean?

It means that the dishwasher is not draining properly due to the drain filter being blocked.

E24 Error Code ' Dishwasher Troubleshooting - Thermador

..

Error Codes ' Dishwashers Support

Thermador https://www.thermador.com > ... > Dishwashers E24 - The dishwasher is not draining properly because the drain filter is blocked. · 1. Check the inlet hose and ensure it's not kinked or damaged. · 2. The pump ...

Thermador Dishwasher E24 Error- How to fix?

yourprimeservice.com https://www.yourprimeservice.com > blog > thermado... Jan 8, 2021 - As a rule, E24 means that the waste line is blocked. Thermador dishwashers are made by Bosch and they are not easy to work on. A common solution ...

How to fix E24 error code on Thermador dishwasher

JustAnswer https://www.justanswer.com > Appliance Repair Apr 29, 2012 - Ok so E24 does mean that the waste line is blocked. Thermador dishwashers are made by Bosch and they are not easy to work on.

1 answer · Top answer: So what is the dishwasher doing exactly? Is it finishing the cycle but it's just not draining.

..

Hi,
Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...

Dishwasher Problems - Waterwill not drain out

heatman101

It is usually caused from food scraps that get caught in the drain filter. It is located on the bottom of the machine under the lower rack. It either pops out or unscrews.

Good Luck

Hi,

Here is a tip that will help you with how to clean that dishwasher up and get it smelling good again...

Dishwasher Maintenance

heatman101

Hi, By the information you've supplied, I'd guess you burnt out the coil in the water/fill valve by running it without a water supply to the valve. Are there any other unusual symptom's or error codes ? i.e. drain pump running none stop ? Can you put water into the tub manually and run a rinse cycle without issue ? In any event the valve is pretty inexpensive, usually about $30 or so. The part # 425458 works on all bosch, thermador, gaggenau, and siemens dishwasher built since the early to mid 90's up to present day. Hope this was helpful to you. Thanks for visiting "fixya" today. Good luck. macmarkus :)

Did it ever drain????

The lid switch is not sensing the door to be closed.

I’m happy to help further over the phone at https://www.6ya.com/expert/josh_87ce33216d7b2148

f code is a fill fault problem to much or to little water to determine the problem is to hit cancel drain buttons on the front of the machine and wait for cl on the display turn off machine and wait 30 seconds turn back on and the first thing you will hear is the drain motor turn on for 15 sec then you should hear the water filling into the machine if you dont hear water filing then check to see if the valve under the sink is open to allow water to fill machine

Hi,
Here is a tip that I wrote that will help you with your dishwasher not draining problem...

Dishwasher Problems - Water will not drain out
http://www.fixya.com/support/r4078724-dishwasher_problems_water_will_not_drain

heatman101