Question about Sanyo DS27910 27" TV

1 Answer

TV won't turn on

Hi There, My Sanyo TV won't turn on. I have unplugged it for more than 12 hours hoping that it will reset & then start, but no luck. When I press the power button on the remote, play button also lights up. To me looks like, its stuck in some other mode & thus its switching on. Any suggestion would be of great help. Thanks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,694 Answers
Re: TV won't turn on

Practice visual acuity technique! Solder any/all bad connects.check power supply. Check tactil switches on front of set. Remove chassis,unplug all connectors,re-assemble,try again.

Posted on Sep 26, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Where is the reset button

Sanyo Service Menu -
Jump to Sanyo TV Service Menu Method 2 - Unplug the power cable. Press and hold the {VOL -} button on the TV while plugging the power cable back ...

Sanyo TV reset button location? ' Yahoo Answers
Jul 27, 2007 - Does anyone know where to find the reset button on a 32" Sanyo TV? The thing is just totally dead and I am thinking maybe if I push the reset it ... I have a Sanyo TV, I accidentally hit the reset button twice. I ...
Aug 6, 2012
36 inch sanyo tv won't change off video 2?
Apr 17, 2010
I accidentally hit the 'reset' button the remote of my sanyo tv ...
Jan 6, 2010
Sanyo DS32224 TV Problem!!?
May 21, 2009
More results from

Nov 29, 2015 | Sanyo DS31520 31" TV

2 Answers

Can't turn off captions on Sony TV


Did you try a hard reset?Unplug all the cords from back for 4 hours and then plug it back.Doing this will reset the factory default. settings.


May 04, 2008 | Sony FD Trinitron WEGA KV-32FS120 32" TV

4 Answers

I need a service manual

please buy the manual at

Mar 24, 2008 | Standard (CRT) Televisions

1 Answer

My RCA Truflat T.V won't turn on and the FPA lock is turned on, I have the original remote. what should i do?

TV won't turn on • Press the TV button. Make sure the TV is plugged in.• Check the wall receptacle (or extension cord) to make sure it is "live" by plugging in something else.• Something might be wrong with your remote control. Press the POWER button on the front of the TV. If the TV turns on, check the remote control solutions on page 26.• The front panel controls may be locked (disabled). Use the remote control to unlock the front panel controls by selecting the Lock Fr. Panel in the PARENTAL CONTROL menu and press OK (box won't have check mark).Buttons don't work
• If you're using the remote control, press the TV button first to make sure the remote is in TV mode.• The front panel controls may be locked (disabled). Use the remote control to unlock the front panel controls by selecting the Lock Fr. Panel in the PARENTAL CONTROL menu and press OK (box won't have check mark).• Unplug the TV for two minutes and then plug it back in. Turn the TV on and try again.TV turns off unexpectedly • Sleep timer might have been activated. Go to page 24 for instructions.• KidPass might have been activated. Go to page 21 for instructions.• Wake-Up timer turned on the TV and no remote or front panel buttons were pressed for two hours.• Electronic protection circuit may have been activated because of a power surge. Wait 30 seconds and then
turn on again. If this happens frequently, the voltage in your house may be abnormally high or low.
• Unplug TV. Wait five minutes. Plug it in again.

Sep 16, 2011 | RCA 20F420T 20" TV

2 Answers

Sanyo 24" flat DS24425 suddenly turned off, won't turn on. Pressing the power button either results in no response or it turns on for a second, then turns off again. No picture. Already tried playing...

Solution to the won't turn on or turns on and turns off in 3 seconds my Ds24425 did.

First thing is very important...unplug the TV and let it set for 24 hours before you proceed.

The voltages inside a TV are EXTREMELY HIGH and proceed with caution!

Place the set face down on a towel on a table and remove the back cover....hex screws around the perimeter and 1 phillips screw near the inputs.
The main board will slide up and out. unplug the degausing coil "white plug with two wires" and the speakers connector. This will make it easier to turn the board and take a look.

What I found with mine was a bad electrolytic capacitor. You can identify I bad cap "capacitor" by examining the tops of each one for bulging or signs of overheating "melted or bubbled plastic covering." The cap in question was C626 with a value of 1000uf, 16volt. I replaced with a 1000uf, 35volt and it works perfectly. The cap is located about center of the board. Carefully unsolder the cap and remove, make sure to install the new cap with the proper polarity...the board is marked with a dot indicating the negative lead of the cap.
Be sure to reattach the white plug and speakers connector and slide the board back into the plastic grooves. Then replace the back cover and test. Good luck! ...Daddio

Feb 02, 2009 | Sanyo DS24425 24" TV

1 Answer

Sanyo TV - HT32744

Lower the contrast first.

If colors not in balance, reduce saturation until "normal" to your eye with whichever color (or color pair) out of balance.

Aug 19, 2008 | Sanyo HT32744 32" TV

1 Answer

Reset Default Settings


Initially, have you tried a full hard reset? If not, pls unplug from the mains. Most current devices would reset and revert back to factory default settings (assuming no internal hardware fault) when unplugged for a considerable period of time (fa couple of hours at least or preferably overnight).

Alternately, pls check if you have "Zoom" enabled.

Hope this be of initial help/idea. Good luck and kind regards.

Thank you for using FixYa.

May 08, 2008 | Standard (CRT) Televisions

2 Answers

TV won't turn on

read from other forum. wouldn't hurt to try, unplug the power for 2 days and plug back in again to see if it will turn on.

Mar 10, 2008 | Sony FD Trinitron WEGA KV-27FS100 27" TV

1 Answer

Tv wont turn on

stephster, check to see if you have a reset button on the back of tv good luck-hope this works for you

Nov 05, 2007 | Panasonic CT-36HL43 36" TV

Not finding what you are looking for?
Sanyo DS27910 27" TV Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sanyo Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66623 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Sanyo Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides