Question about GE JGBP33 Gas Kitchen Range

Open Question

Ge cafe range broiler flame to high - GE JGBP33 Gas Kitchen Range

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: GE XL44 Spectra Gas Oven Range

Replace the electric ignitor, I did today... Temps are hotter than ever. $60 from an appliance suplier, easy to install.... Trust me

Posted on Jun 30, 2008

  • 6 Answers

SOURCE: oven produces soot when running, broiler ok, stove top ok

Al, you need to seat the needle valve on the bake. Remove the bottom drawer, right below the bake burner you will see the nut just below the air shutter adjustment. Turn this nut clockwise a few times, it might seem hard but just do it. Then try the bake again, you should have a nice bluel flame. Tenbears.

Posted on Dec 20, 2008

MNTECH
  • 1543 Answers

SOURCE: My broiler works - but the oven does not - GE Dual Fuel range

Thanks for providing the full model number, which allows us to look up part numbers and see exploded views of your product.
Most likely the bake ignitor is bad (even if it still glows, it may not draw enough amperage to allow the gas safety valve to open). One way you can test this on your model is to swap out the broil ignitor for the bake ignitor, as they are the same part number on your model. (part number WB13T10045) The broiler is normally used much less than the oven, so the part does not fail very often on the broiler. You will have to take the cover off the floor of the oven, then the flame spreader, to reach the burner area. The ignitor is the rectangular part at the back, on the side of the burner. (only two wires to deal with) (By the way, for future reference, your model number ends is SS, as in stainless steel, not a 55)

Posted on Jan 15, 2009

pumpkinman
  • 1144 Answers

SOURCE: GE Range JGBS 23...The Broiler does not shut off

the switched has malfunctioned. you must unplug the stove to turn it off do not leave it on be very carefull unplugging it do not touch the prongs its 220 volts?

Posted on Jun 20, 2009

Maytag317
  • 1136 Answers

SOURCE: broiler works, oven settings - no flame, no heat.

Hi, it sounds like the oven ignitor might be bad. Remove the floor panel inside the oven and you will see the ignitor attached to the burner assembly. Turn the oven on and see if it glows. You can test the connection for the ignitor and see if it gets 120V to it. The most common problem with the gas oven is the ignitor. Most of the time, the ignitor glows but is not strong enough to open the gas valve.
Please let me know if this was helpfull or if I can assist you further.

Thanks
Vic

Posted on Jul 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Broiler flame becomes weak


check lower broiler for clogs - spider webs etc

Jul 08, 2014 | Kenmore 79012 / 79014 / 79019 Gas Kitchen...

1 Answer

BROILER DOES NOT BROIL-coils will not get hot


replace the "broiler Glow Bar" and you will be good to go. Here is that part to order.
There is also a video on that parts page to show you how to make the repair.

Oct 25, 2013 | GE Cafe CGS980S Kitchen Range

1 Answer

The oval burner has only very low flame, even when set on high


Every one of these ranges that I have seen with the oval style burner on them have a smaller flame then the normal round burners. And there is very little difference between the low and high settings. It sounds like what you are experiencing is normal. What the GE repairman was adjusting is called the "simmer stop". There is a small flat head screw inside the burner stem. By turning this screw you can adjust the size of the burner on the low position of the burner knob. This should be adjusted to where the burner still stays on when the knob is at the lowest setting. I do not think that you need the burner repaired. From my experience they are all like that.

Mar 10, 2010 | GE Cafe CGS980S Kitchen Range

2 Answers

The oven pilot does not light. The broiler will not work. The only thing that does is the light. GE XL44 range. The burners light and the pilots stay lit.


    If you have standing pilots, make sure the pilot for the oven/broiler is lit as well.  When you turn the thermostat up to call for heat, you should see the pilot get larger. That larger pilot flame heats a hydraulic sensor and opens the main burner valve.  

    Jan 10, 2010 | GE Profile Spectra JGBP90 Gas Kitchen...

    1 Answer

    GE JGSP28 Range broiler problem: flame comes out when door opened


    The air shutter should be completely open. A possible adjustment may be necessary towards the closed position. The orifice needle at the orifice hood may be too tight. Take a 1/2 inch open end wrench and turn the hood counterclockwise to reduce pressure on the needle. Do this with the air shutter completely open. Your flame should reduce in size. The best flame would be about 1 inch long with white tips.
    Make the adjustments with the flame off. Then light it and check it. If more adjustment is necessary,turn the broiler off before adjusting.

    Sep 16, 2009 | GE Profile Spectra JGBP90 Gas Kitchen...

    1 Answer

    Oven produces soot when running, broiler ok, stove top ok


    Al, you need to seat the needle valve on the bake. Remove the bottom drawer, right below the bake burner you will see the nut just below the air shutter adjustment. Turn this nut clockwise a few times, it might seem hard but just do it. Then try the bake again, you should have a nice bluel flame. Tenbears.

    Dec 20, 2008 | GE Spectra JGBP30 Gas Kitchen Range

    1 Answer

    GE XL44 Spectra Gas Oven Range


    Replace the electric ignitor, I did today... Temps are hotter than ever. $60 from an appliance suplier, easy to install.... Trust me

    Jun 08, 2008 | GE Profile Spectra JGBP90 Gas Kitchen...

    Not finding what you are looking for?
    GE JGBP33 Gas Kitchen Range Logo

    Related Topics:

    19 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Kitchen Ranges Experts

    Dan Webster
    Dan Webster

    Level 3 Expert

    8220 Answers

    Ismael Rodriguez...

    Level 2 Expert

    162 Answers

     Fix Your Board
    Fix Your Board

    Level 3 Expert

    310 Answers

    Are you a Kitchen Range Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...