Question about Harman Multimedia HK 3390 Receiver

1 Answer

I plugged my Harman HK-3390 on 220v and receive the message "VOLTAGE PROTECTED.... CHECK THE INPUT" always whey I turn it on 110v. Whats the code to unlock it? Regards

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Master
  • 12,223 Answers

You must read your owner manual, or download from www.retrevo.com or www.manualslib.com and get it free

God bless you

Posted on Oct 12, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i reset the hk3770


Place the receiver on Standby mode so that the Power Indicator turns amber. Press and hold the front-panel Tun mode Button for at least 5 seconds until the receiver goes on and a reset message appears in the display.

Mar 01, 2015 | Harman Kardon Harman/Kardon HK 3770 stereo...

1 Answer

Why Harman Kardo HK 3490 goes into DSP voltage protect mode


This amplifier can go into protection if one of the low ohm resistors on the power module that is soldered to the transformer is defect. Check out R951 and R952, they are both 0R47 (0,47ohm). They are often broken and measure some kilo ohms.

Apr 29, 2014 | Harman Kardon HK 3490

1 Answer

HK DPR 2005 is shutting off by itself after running for about 5 seconds


when you connect any device you should always have the power off. if you connect while power is on you will blow that input up after time. sorry for the bad news

Apr 13, 2014 | Harman Kardon DPR 2005 Receiver

1 Answer

My receiver works fine when I plug my iPod into it, but when I plug my turntable in I can't get any sound. Any idea?


The phono cartridge on your turntable puts out a much lower level signal than your iPod. Back when turntables were popular, all receivers had a special phono input to take care of that. Your modern HK receiver does not have a phono input, so you need to get an external phono preamp. Plug the turntable outputs into the phono preamp inputs, then plug the phono preamp outputs into one of the audio inputs on the HK, like where you connected the iPod.

Oct 08, 2013 | Harman Kardon AVR 745 Receiver

1 Answer

I have hk 3390 reciever


What I did is bought a splitter, plugged it in the headphone jack at the back of the iMac. One side goes to my computer external speakers and one to my receivers aux input, or tape one input. I works, just make sure that the volume on your iMac is not higher than half way, or your sound might be distorted and your external computer speakers are off. Not unless you want them on. Keep your iTunes EQ set to flat, that also will create unwanted distortion. Use you receiver tone controls if needed. Hope this works for you, that's how I did it.

Jan 19, 2013 | Harman Multimedia HK 3385 2 Channels...

1 Answer

Harman Kardon HK 3250 Receiver- how can I connect my turntable? there is no PHONO input


These depends on what model of turntable you have .

On most it can be connected on the inputs you have mentioned ,

If only , a RIAA preamp is included in it.

You may need one, if it doesnt have,


sample phono preamp:

Phonopreamps.com Home Page

can also be connected to Aux or Tape

Oct 08, 2012 | Harman Kardon HK 3250 Receiver

1 Answer

Will not turn on. Message Protect


audi amplifier IC,s burned need to replace them

Jun 05, 2010 | Harman Kardon HK 3480 Receiver

1 Answer

Fiber Optic input


No gots. The 3485 is pre-digital stereo-only.

From the manual, page 19

"You may have observed that the HK 3485 is not equipped with digital audio inputs or surround sound decoding. If you prefer the complete home theater experience, you may wish to consider purchasing a fullfeatured Harman Kardon AVR Series audio/video receiver. However, we hope you will find that using a DVD player with the HK 3485 in smaller settings, such as a bedroom or den, surpasses the audio performance of most televisions, including those with onboard stereo speakers."

Apr 13, 2010 | Harman Kardon AVR 240 Receiver

Not finding what you are looking for?
Harman Multimedia HK 3390 Receiver Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harman Multimedia Audio Players & Recorders Experts

Josh Whitehead
Josh Whitehead

Level 3 Expert

1148 Answers

Brad Brown

Level 3 Expert

16210 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Harman Multimedia Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...