My printer doesn't print anything

Hi,
Please get it downloaded here :
www.nodevice.com/driver/MP390/get34271.html

Regards. Jay_GT

Try to print a test print using printer itself. That can do using printer buttons. If the same printout comes blank, Your printers ink cartridges are empty or dry. Replace them and see results..

Hi, i suspect the ink you bought is not compatible with the printer, try print test page and see what happens.if it is still blank,then, change the ink cartridge.

Compliment and wish you best of luck.

Ho,

No this will not work as the printer has no way to install the dongle into it's operating system.

In order to make it wireless you will need either a wireless access point if the printer already has an ethernet port a wireless USB print server if not.

Look at model # PM111UW on www.startech.com for refernece.

Chris

I had this problem several times, had to buy new print head until I found that to clean it you should use ammonia. It really worked for me. You should really try ammonia it does work.

Dont do anything such stupid things go to authorised service center do will do the needful

how do i install print head for canon multipass mp390

My MP390 wasn't printing black, despite the cartridge(s) being new. I reinstalled CD and then it worked. The next time, it did not print again. I, then d/l driver from online...same thing. worked once and then not. Also, it doesn't copy anything in black

I've had several of the MP390 printers die on me, usually just out of warranty. This is not a print head issue. Sounds like its time for a new printer.

I just ran into a similar issue with my MP390. Actually both the color and black inks were not printing very well. I would get very inconsistent printing. Fixed the problem very easily and quickly as follows: On the top of each print cartridge, there is a small hole. Remove the print head (lift the gray bar at the front of the print head and lift out the print head) with the cartridges still in place. Holding the print head over a piece of paper/paper towel, blow into the holes on the top of the cartridges (either directly or using a straw/tube of some kind). You should get ink coming out of the botton of the print head, both color and black. Replace and print head and test print.