Question about Washing Machines
TWO WEEKS OLD!!!! Stopped it mid cycle, would not re-start. Flashing F-01
F01 finally fixed after 2 repairmen and 2 circuit boards replaced/5 weeks of loaundromat! ! HINT have your repair technician check the boards. Be sure to have them especially check which wires are connected to which areas of the board. It could be that the wires are connected to the wrong place on the board. Good luck!
Posted on Sep 26, 2007
Tips for a great answer:
Jun 04, 2014 | Whirlpool Duet GHW9150P Front Load Washer
The pump on your washer is apparently not working. It should have pumped the water out when the FL was displayed. You should schedule service and let a technician diagnose and repair the washer.
Flood Condition F L "FL" flashes if any overfill condition occurs. This condition occurs when excessive water in the tub causes the overfill switch to trip. The control must realize that the trip was due to an overfill condition instead of a suds lock condition in order for "FL" to be displayed. With an overfill condition, the beeper repeats a warning every 10 seconds with no time out. The pump is cycled in drain mode for 30 seconds on, 30 seconds off until the overfill switch resets or power is discontinued to the unit.
Press STOP/CANCEL to clear the display.
Mar 21, 2011 | Whirlpool Washing Machines
Jan 05, 2011 | Whirlpool Washing Machines
Oct 16, 2009 | Whirlpool Duet GHW9150P Front Load Washer
May 30, 2009 | Whirlpool Washing Machines
Mar 29, 2009 | Whirlpool Duet 3.8 cu. ft. Front Load...
Dec 12, 2008 | Whirlpool Duet 3.8 cu. ft. Front Load...
Oct 08, 2008 | Whirlpool Duet GHW9150P Front Load Washer
Jun 24, 2008 | Whirlpool Duet GHW9150P Front Load Washer
316 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: