Question about Pioneer DVR-520H DVD Recorder

1 Answer

Power off after recording

My DVR powers down completely after recording. I can not power it back up without removing the power cord and then putting it back. Sometimes it can take many many times

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Hi All,

This is a power supply problem.... the MR2920 stanby IC miss behaved, it power off and fail to power back on.

Solution, get pioneer power supply replacement or take the dvd recorder to your local electronic service repair to take a look at the power supply circuit.

Best of luck
Kenny

Posted on May 01, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Pioneer DVR 320 dvd recorder just stopped working. Iv'e checked the power source thats Ok. Is their a fuse or something or is it old age?


Tries unplug,replug the unit back like about an hour later,see if might just in it protected mode,see if the unit reset itself and work again.Yes,there is a fuse in the back of the PCB board,it seat near the power a/c cord.U can tries to replaced the fuse and tries it out.But all modern electronic devices saldum burn fuses in a normal uses.

Jan 29, 2011 | Pioneer DVR-320S DVD Recorder

2 Answers

Wat is the admin password or a null pssword


The admin passward is a system operating passward when we know admin passward then we operate operating system.

Nov 06, 2010 | Revo America 8 Channel Complete Digital...

1 Answer

I own a Pioneer DVR-220 dvd recorder and my problem is that the unit will not power up. I've tried disconnecting the ac power cord from the Monster Power power source and connecting the power cord via an...


I replaced two capacitors, (1) 10 volt, 1000uf and 10 volt 3300uf..They both sit on the power board that can be removed from the unit..You will have to unsolder the bad capacitors and put in the replacements..This wasn't hard to do...

Jun 26, 2010 | Pioneer DVR-220 DVD Recorder

2 Answers

Need to determine wiring connections from camera to dvr for Samsung SSC DVR


Hi


Thanks for using FixYa. Please see the link to hook up DVR with camera---

Hookup Camera with DVR

Please do accept the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

Jun 16, 2010 | Samsung SSC DVR Digital Video Recorder...

1 Answer

HOW DO I INSTAL A TOSHIBA EXTERNAL DVD RECORDER TO SAMSUNG SMT-190DN..


Hi,

If your are going to install the dvd recorder into your other device, follow this few steps.

  1. Place your external DVD Multi-Recorder drive in the stand. Otherwise, lay it down horizontally if you're not going to be using the stand.
  2. Turn on device.
  3. Plug one end of the USB cable into one of the dvr USB ports. Then connect the other end into the external DVD Multi-Recorder drive.
  4. Plug the power cord into the AC adapter. Then connect the cord into the drive's jack. Connect the other end into the power outlet.

Hope this helps

Nov 23, 2009 | Samsung 4 Channel Dvr

1 Answer

Random power failure


completely disconnect the power cord 15 mn and then reconnects, It's a power problem i think that is the condensators which are out of service

Sep 27, 2009 | Pioneer DVR-520H DVD Recorder

1 Answer

Whiny dvr


sounds like the hard drive in the dvr is bad - they're easy to replace though - just follow the steps below.

  1. Step 1 Disconnect your DVR by unplugging any cables connected to it, including the power cable. Remove the screws located on the back of the unit that hold the top cover in place. There are usually two to six of these screws, depending on the model of DVR. Lay these screws in a safe place where they won't get lost, and slide the cover off.
  2. Step 2 Locate the hard drive. This is a rectangular metal unit that measures 3 1/2 inches wide. It is usually located away from the other hardware, often in its own bracket. There will be two to four screws holding it in place. Remove these, disconnect the cables connected to the drive, and slide it out of the system.
  3. Step 3 Check the label of the drive to see if it is IDE or SATA. It will say which one of the two interfaces it uses. Any replacement desktop hard drive of the same interface type will work in your DVR. Avoid using a laptop drive, because they won't fit and aren't designed for the high-stress environment of video streaming.
  4. Step 4 Place the new drive into the brackets, and replace the screws that were removed from the old one. Plug the data and power cables into this drive. They will insert the same way they came out of the old one. Once the drive has been installed, put the cover back on the DVR unit, and replace the screws. Hook the DVR back up to the television, and it will be ready to record.

Sep 12, 2009 | Cyberhome DVR 1600 DVD Recorder

1 Answer

Unable to record or skip backr skip forward or skip back. I have tried the power switch bit several times.


In this type of situation the solution would be to complete what is called a Front Panel Reset, this can be completed by completely unpluggin the receivers power cord from the wall and leaving unplugged for 10 seconds and then plug back in- but do NOT power your receiver back on. The receiver will complete a reset process which may take up to 5 minutes, during this time the receiver will power back on by itself and go through the necessary screens, once the receiver finishes downloading the program guide you will be able to verify if the DVR issues are resolved. If this problem happens repeatedly or has already happened repeatedly, please contact me directly so I can assist you and we can rectify the DVR issue with another option. If the issue has not been resolved already or you are still experiencing please e-mail me at Kirstie.Filosa@Dishnetwork.com. I hope this helps you!
-Kirstie DISH Network

Aug 19, 2009 | DISH Network DVR-625 DTV Receiver /...

1 Answer

How to stop recording,without killing the power?


My record lock is turn off, but every time I press the record stop to stop record it takes me to the password screen where I must enter a password before I can stop the recording....This piece of xxxxx is stink. I hate my Samsung SHR-1040...I cant even talk to Samsung about it.....When I call, they transfer me to India and they dont even know what a DVR is......I told them DVR 10 times, but they keep repeating to me " VCR"

Nov 02, 2007 | Samsung 4 Channel Dvr

Not finding what you are looking for?
Pioneer DVR-520H DVD Recorder Logo

617 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pioneer Televison & Video Experts

The Knight
The Knight

Level 3 Expert

74383 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Jaime Hernandez

Level 3 Expert

2318 Answers

Are you a Pioneer Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...