Question about Sony VPL CS10 Multimedia Projector

1 Answer

Projector turns it self off

I think that the lens cap sensor says that the cap is on and shuts down the projector

Posted by on

1 Answer

Re: projector turns it self off

Verify the sensors, and the Cooler for the mirrors.

Posted on Dec 09, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

3M SCP712 projector shuts down after an hour--can't turn back till it cools

the problem is with overheating. Look whether the cooling fan doesn't work or air filter is cloggy with dust. OK.

Nov 08, 2011 | 3M SCP712 Projector

1 Answer

I have a sanyo PLC-XE40 model projector. the problem is when i power it on everything works fine ,but after like 30 mins it shuts down automatically as if i have powered it off by my self. it shuts down...

There is a lens/lamp filter which must be taken out and cleaned, use good air jet to blow and brush out dirt. If the filter is clogged then the lamp might heat up and so shut down..
if the fault does not clean try and force cool the unit, if not there is fault in the power supply, possible lamp problem or circuit error on load or heat.
You will need to open and use a test bench to check out the sections, one by one, use of multimeter and good equipments may be needed . If not take help with consensus.

Sep 13, 2011 | Sanyo PLV-Z4 Multimedia Projectors

1 Answer

Infocus IN102 projector. First time it shut down while being used. after that each time it was turned on, it shut down after some seconds.

I am Maggie from Yue Yu Electronic and I am in charge of the export business.

We, specialized in multi-media projector system engineering and maintenance service, wholesale and retail all brand projectors and its accessories (lamps, ballasts, polarizer, light tunnels, filters, burners, main boards, LCD panels, color wheels, lens, remote controls, etc.), have exported projector parts for many years.

If you need any projector parts, do not hesitate to contact me.

Email address:

Aug 15, 2011 | InFocus IN102 DLP Projector

1 Answer

Projector doesn't turn off when I press the off button ....I have to disconnect the power cable to shut it down

All projectors take a bit of time to shut off, when pressing the power button it first shut off the lamp, than the fan runs for some time after to cool down the lamp, have you waited long enough??? if after a minute or two, if it is still running than try pressing the power button on the unit it self, it could be a defective remote as well.


Jun 29, 2011 | Epson EMP-6100 Projector

1 Answer

Sanyo plc-sw30 i have a problem when i power on the projector , there is no power lamp on a very slow light is visible and the projector shut down and the fan are in very high power

The uProcessor thinks that it has overheated and is frantically trying to cool down what it thinks is a hot lamp.
This condition has many causes from an exhausted lamp to lamp ballast fault or even a power supply fault or a heat sensor/fan fault.

Mar 30, 2011 | Sanyo PLC-SW30 Multimedia Projector

1 Answer

I have Sony VPL CS6 projector and the lens cover stays open and wont shut to cover the lens!! The Lens/Cover light on it flashes? It does project for about 15seconds or so but then goes off, this is when...

It is possible that there can be few reasons for the fault siad:
1.the lamp can be faulty
2. the filter can be clogged.
3. the lens cap trigger switch can be faulty and staying on
4.The power supply can be faulty, not delivering the power but shuts off.
5,the main processor board can be faulty witth errors.
It might need board swapping to confirm.

Sep 25, 2010 | Sony VPL CS6 Multimedia Projector

1 Answer

I have a Sony vpl-1 projector that on initial start up it shuts itself off We have to keep cutting the power completely and start it again, this we have to do for around 4 or 5 times before it works...

If the projector has a lens cap, you have to help the projector to open it completely. Just use your finger and push the cap all ther way. On the projector I have this vis the case. there is a micro switch at the end og the lens cap opening mechanism.

Aug 29, 2010 | Sony Cineza VPL HS2 Multimedia Projector

2 Answers

Projector screen displaying "Searching" message. Does not recognize computer. Worked with one of your associates (Guru?) and we tried a number of solutions but none worked. She asked that I come back to...

If you are connecting to a laptop then you may need to hold the function button down and press F1, F2, F3 etc. there should be a sign with the latop on there and a sign with an external device (monitor,PROJECOR)
hope this information was useful to you.

Jan 21, 2010 | InFocus Multimedia Projectors

1 Answer

SANYO PLV-70 - powers up for approx 5 secounds and then turns of

we had this problem and it ended up being that one of the fans under the lens assembly was not working, causing the system to shut down when it tested it at startup

Dec 11, 2008 | Sanyo PLV 70 Multimedia Projector

Not finding what you are looking for?
Sony VPL CS10 Multimedia Projector Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Multimedia Projectors Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

The Knight
The Knight

Level 3 Expert

66623 Answers

Are you a Sony Multimedia Projector Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides