Ryobi RY60511A
Champion plug RCJ6Y - gap is .22
I have original manual.
According to the NGK website, the 25cc engine from Ryobi requires a .020 gap. They did not, however, specifically mention your model.
The champion website suggests a .030 gap. Again, this was only shown under the cultivators section, and did not specifically mention your model.
If all else fails, contact your nearest service center:
http://www.ryobitools.com/support/service_center_locators
SOURCE: Ryobi Tiller, model RY60511A, will not start. Air
mine was a total pain. I yanked on the rope so many times, it flew out of the keeper,and when I replaced it I ran it UNDER the fuel tank cutting a slot in tank. I also blew out the primer bulb. AFTER the replacement tank I arrived, I discovered rolling the machine forward helped the flow to carb and did not require priming. Now I need to fix throttle cable. But all in all, a tough little machine.
2,897 views
Usually answered in minutes!
×