The "OK" button won't work - Logitech Harmony 700 LCD Remote Control

It's a bad picture, but the button in the centre of the 4-way arrows is the enter button on nearly all remotes.

https://www.google.com/search?source=hp&ei=ikZ_XtvGA6SOlwSCto2QDw&q=I+have+a+1986+Dodge+D-150+Pickup+and+the+Radio+won%27t+switch+to+FM+when+the+button+is+pressed.+The+AM+works+fine.+Everything+else+is+ok.&oq=I+have+a+1986+Dodge+D-150+Pickup+and+the+Radio+won%27t+switch+to+FM+when+the+button+is+pressed.+The+AM+works+fine.+Everything+else+is+ok.&gs_lcp=CgZwc3ktYWIQAzIOCAAQ6gIQtAIQmgEQ5QIyDggAEOoCELQCEJoBEOUCMg4IABDqAhC0AhCaARDlAjIOCAAQ6gIQtAIQmgEQ5QIyDggAEOoCELQCEJoBEOUCMg4IABDqAhC0AhCaARDlAlDqE1jqE2DKiAFoAHAAeACAAdQBiAHUAZIBAzItMZgBAaABAqABAaoBB2d3cy13aXqwAQY&sclient=psy-ab&ved=0ahUKEwjbs-CQmb3oAhUkx4UKHQJbA_IQ4dUDCAU&uact=5#kpvalbx=_W01_Xqv_DIHIaIbagKAJ23

pull shafe out it is likly broken to find out between timer and shaft look to see if timer move by itself and if it does sorry u have broken shaft

Button probably bad.
Remove button from dash connect multimeter and set to continuity and press button listening for beep

Water still in the bottom of the drum. Empty, clean filter and check pump is turning. Once pressure switch is satisfied no water is left it'll allow the door to open, assuming the door interlock is still ok.

Remove the cover and check the drive gear. It is a white nylon gear just in front of the motor. It will be obvious if it is bad. Tell me - if it won't open how do you know it won't close?

To format a card, press the MENU button, use cursor-up/down to select the wrench icon and press the OK button, use cursor-up/down to select "Format" and press OK.
Be aware that the Z612 only works with cards up to 2GB in size. If you have a larger card, you won't be able to format it in the camera.

TV won't turn on • Press the TV button. Make sure the TV is plugged in.• Check the wall receptacle (or extension cord) to make sure it is "live" by plugging in something else.• Something might be wrong with your remote control. Press the POWER button on the front of the TV. If the TV turns on, check the remote control solutions on page 26.• The front panel controls may be locked (disabled). Use the remote control to unlock the front panel controls by selecting the Lock Fr. Panel in the PARENTAL CONTROL menu and press OK (box won't have check mark).Buttons don't work
• If you're using the remote control, press the TV button first to make sure the remote is in TV mode.• The front panel controls may be locked (disabled). Use the remote control to unlock the front panel controls by selecting the Lock Fr. Panel in the PARENTAL CONTROL menu and press OK (box won't have check mark).• Unplug the TV for two minutes and then plug it back in. Turn the TV on and try again.TV turns off unexpectedly • Sleep timer might have been activated. Go to page 24 for instructions.• KidPass might have been activated. Go to page 21 for instructions.• Wake-Up timer turned on the TV and no remote or front panel buttons were pressed for two hours.• Electronic protection circuit may have been activated because of a power surge. Wait 30 seconds and then
turn on again. If this happens frequently, the voltage in your house may be abnormally high or low.
• Unplug TV. Wait five minutes. Plug it in again.

First, if the memory card is larger than 2GB then it won't work in the camera and can't be formatted.

If the card is 2GB or smaller, then turn the camera on, press the MENU button, use cursor-up/down to select Setup (three slider controls) and press the OK button, then use cursor-up/down to select "Format" and press OK.

i gues you have dropped it or it got wet. Bring it to your local telephone shop and ask to clean it. That only cost like 10 dollars and when they put it back together the align the keyboard

thats the best way to go


good luck

rene