Picture curves in @ top and bottom and color convergence is off. was fine yesterday.

Tv have a problems known as a convergence problems,it is dead.The tv convergence board it is dead,that why ur tv picture are R,G,B colors lines mis alignments,have colors shadows picture or 3D picture lood alike?The tv convergence board require changes 2 STK convergence ICS and some or all of it resistors too.To fixed the tv convergence board to solved the tv convergence picture problems.The shop will cost u like $300-350 for parts and labors.

You will need to replace your two convergence I.C.s.They are two large IC mounted on a large aluminum heat sink.Replace both,look for any burned resistors near them,replace those if needed,and readjust your convergence. Good Luck

Let me know if you need any further help

If the entire screen is curved, and it is not taking the whole screen, then you have a vertical deflection problem.

If the colors are double and do not match, with lines of different colors around pictures , then you have a convergence problem, often caused by a faulty convergence board.

The curving effect can be a side effect of bad convergence, or you may have both problems at once.

Unless you are a TV repairer yourself, better calling technical support. Usually you can ring the number listed on the owner manual.

If the picture is curved on the top / bottom and looks like a "rainbow", the convergence amps need to be replaced.

REPLACE ALL STK?????? CONVERGENCE AMP IC'S & CHECK RESISTORS FOR THAT CIRCIUT

if it is bowing from top and bottom your looking at a convergance problem if you keep using your tv soon there will be no picture at all when the board crashes... convergance board needs to be replaced... hope this helps..

This is a convergence problem that could be as simple as poor solder connections at the convergence ICs. If you can solder and are comfortable working inside the set where there are potentially dangerous high voltages even when unplugged, you can fix this yourself. Let me know if you wish to attempt the repair and I'll provide more details.,

Dan

this is a indication of convergence problem. the curved picture indicates total or a complete loss of convergence power. I first recomend you read the artilce in tips in tricks section. the fl231 problem it might be this if you do not have the convergence options in setup of customer menu. if not it might be a convergence power board issue

Depends on your geographical area...300-450

This indicates a convergence problem..convergence power supply probally.. however ive seen 2 other cuicits cause this ..