The speakers on my flhtcu 2006 cut out if i toggle the speaker switch they come back on. I have replaced the speaker switch. with no effect.

First off, make sure your speaker switch is in the proper position. You would be surprised how many folks come to the shop with the same problem because the switch is in the wrong position! If this isn't the problem, check to make sure the speaker connections are ok. If the radio needs repair, it will have to be sent by your dealer to United Radio. Retail cost for radio repairs is $400 if you don't have extnded warranty.

Hi, Back track from speaker to stereo somewhere in the line.there maybe bare wires or broken check fuses too. Fuses box under seat or near by. Good luck.

If they are cutting in and out, you have a bad connection or a loose connection. Make sure it is grounded. Run a volt tester on the wires that run to the speaker. If no test, buy new wires and replace.

Sounds like vibration damage to the audio circuit. Verify the connection to the speaker switch. If all is good, radio will need to be repaired. Contact Iron Cross Audio (www.ironcrossaudio.com) for repair options

Hi,

Your right, the remote will not switch the speakers.
There's no remote input on the power amp, so there's no possibility to switch between A and B speakers.

regards,
Gerard

hi there
on the back of this unit is a green brake wire you need to buy a 3 pined toggle switch ...........you need to take a small but mid size length speaker wire and attach to 12v (red wire) going into back of kenwood unit add another speaker wire to the ground wire (black wire) of kenwood unit... now on the 3 pined toggle switch add the power speaker wire to the toggle switch add the ground speaker wire to the toggle switch once this is done add the green wire to the last toggle switch pin........put the kenwood unit back in dash.......now turn the car and toggle switch on...........put in a DVD and if screen shows DVD all is done...... but if the screen does not show the DVD......just switch the green wire with the black wire on the toggle switch and now it should work
hope this helps

I have a db 1210 and i need the wireing plug for the speakers can you help