Question about GE Profile Prodigy WPSE4200A

1 Answer

GE Prodigy WPSE4270 dead

Front panel does not work at all neither the washer. Field service diagnostic on front panel lights in the washer itself reports as "damage eprom". It is there any way this can be reprogramed or PCB considered as service part ??? Or is it something else??

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers
Re: GE Prodigy WPSE4270 dead - GE Profile Prodigy WPSE4200A Washing Machines

Replace main board


Posted on Oct 15, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

2 Answers

My GE Profile Prodigy WPSE4200A Washer does not spinning for drying and it smells like burning rubber. But it does aggitate for washing. It is a belt issue or could be some electronic device issue?


Problems with a washing machine not spinning or not draining are often interrelated..

If you are having a problem with your top load washer then check out thistip...

Washing Machine does not Pump or Spin

If you are having problems with your front load washing machine then checkoutthis tip...

Front Load Washing machine not draining and or not spinning


Oct 03, 2010 | GE Profile Prodigy WPSE4200A

1 Answer

How do I open the washer up to check and see why it is leaking water WPSE4200AOWW

You can remove the front panel by pushing in the two retaining clips in the seam where the panel meets the washers top using a putty knife, while you pull the top of the front panel forward.

Jun 20, 2010 | GE Profile Prodigy WPSE4200A

1 Answer

How to remove the front panel of a Ge Profile Prodigy Washer

belt could be burnt up or off but need to know the model

Nov 28, 2008 | Washing Machines

1 Answer

Front Panel Removal

slide a putty knife in about an 2 inch in from each corner pry the clips up and pull the front off.

I think you where misled the washer will auto stop fill when the pressure switch in satisfied...if it is working then you can't make the washer leak water on the floor no matter how much you put in it,,

There is a small Tube that goes into the pressure switch at the left side it may have came off.

also it may leak from the a cracked outer tub.. they are very thin plastic ...

let me know if I can help...

I sou

Aug 15, 2008 | GE Profile Prodigy WPSE4200A

2 Answers

Ge prodigy wpse4270aoww won't rinse or spin

try to clean out the water pump lines from pump to out to the drain

Feb 25, 2008 | GE Profile Prodigy WPSE4200A

1 Answer

Spin and Agitate problem on GE Profile Prodigy WPSE4200A

This machine uses an electric water pump. I would check to motor. Remove the front panel and operate the machine to see if the motor is working. Check this by listening to the motor and watching the belt. If you hear the motor but the belt does'nt move then there may be a problem with the pulley or motor clutch assy.

As far as not draining or pumping water ? Check the wiring from the pump to the control panel. If these wires are alright then i suspect the pump.

Nov 15, 2007 | GE Profile Prodigy WPSE4200A

1 Answer

Fixing a clogged pump on GE Profile washer

Take a putty knife and slide it in between the front panel and top to pop the clips that hold on the top. Remove the front panel and you will see the pump down in the front corner. Remove the hoses (watch for water) and you should see any clog. Check hoses and drain line (home) to be sure there is no clog in those while you have it apart. Be sure to unplug your machine before working on it as well. Good Luck!!! Jim

Sep 09, 2007 | GE Profile Prodigy WPSE4200A

1 Answer

GE Profile Washer

1) Most GE appliances have service manuals. By the manual because it will save you the repair services for the life of the machine. 2) I am not familiar with the GE Profile, so I don't know if it has dial knobs, or control panels. Any way, your problems seem like the timer unit is the problem. If it has dial knobs, the timer costs about US$100 - $150. The control panel circuit probably costs that much. You can buy the service manual and parts from Sears or parts services

Aug 19, 2007 | GE Profile Prodigy WPSE4200A

3 Answers

GE Prodigy washer

try with another preset(got 14), and see to compare whats happens, any way as another (dont remember who) tech of this forrum say, "if it not broke dont fix it"..good luck

Aug 10, 2006 | Whirlpool AWM029 Front Load Washer

Not finding what you are looking for?
Washing Machines Logo

220 people viewed this question

Ask a Question

Usually answered in minutes!

Top GE Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Tim Whalen

Level 3 Expert

3056 Answers

Are you a GE Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides