Question about Proform CrossTrainer Treadmill

1 Answer

Proform 515s treadmill motor won't start

I have a proform 515s treadmill and when I turn the power on the console works, but the motor and belt do not run. I have tried resetting the circuit breaker, but that hasn't made a difference. Any ideas as to what the problem could be?

Posted by on

  • 8 more comments 
  • gulatirahul Apr 29, 2009

    When I power on the treadmill, there is this buzzing sound (like the one when we get when we increase/decrease height of belt). When I remove the safety switch, console lights on but nothing happens. When I put back the safety switch, console lights off and buzzing sound starts and treadmill does not work.

  • Anonymous Mar 17, 2014

    after a spark was seen when power to the treadmill, the cons
    ole died

  • Anonymous Mar 17, 2014

    Locked in tilt position and belt will not run.

  • Anonymous Mar 22, 2014

    Replacing motor controller ,not sure where the gray ,red, and yellow wire with the red end goes . Proform 515s is model number of treadmill I own.

  • Anonymous Mar 23, 2014

    belt doesn't work

  • Anonymous Mar 23, 2014

    Replaced motor controller and still no power .

  • Anonymous Mar 23, 2014

    no power

  • Anonymous Mar 24, 2014

    My 542 E... The motor runs but it does not turn at all...is there anything i can do? is there service available?

  • Anonymous Mar 25, 2014

    the Rolling carpet is at the upper position and only motor run no function work????

  • Anonymous Mar 26, 2014

    It is a proform treadmill in south africa

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

If the colse buttons make a chirping noise when you push them the console should be Ok. If there is no chirping noise with the push it is a bad console. If everything but the speed works it will probably be your motor controller that is bad.

Posted on Apr 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a proform 505cst. When I push start, the motor seems to short out. The motor controller LED blinks four times.


Customer Reviews: Proform 505 CST Treadmill (2014 Model)

www.amazon.com/Proform...Treadmill.../B0048HS02...

Amazon.com, Inc.Start here. ..... I was worried it would fall out with the vibration but, as I mentioned earlier, ... The 10% incline and the max speed on this unit more than serves the need ...The sound from the belt and motor is very acceptable (but then its only been .... This morning i was using it for the first time and this treadmill seems great.

Amazon.com : Proform 505 CST Treadmill (2014 Model ...

www.amazon.com > ... > Cardio Training > Treadmills

Amazon.com, Inc.Start here. ..... The ProForm 505 CST Treadmill is designed to get you moving. ....This morning i was using it for the first time and this treadmill seems great. ... I would suggest for anyone that gets this to open up the motor cover and take a look at ...graphics on the instruction manual and figure out what piece went where .

505 CST ' Proform


Jan 11, 2016 | Proform 505CST Treadmill Walking Deck

1 Answer

Proform 560 crosstrainer treadmill powers on belt won't turn


LUBE THE deck belt+ rollers bearing too. God bless you
proceed according with the video attached.

Jan 07, 2013 | Proform Exercise & Fitness

1 Answer

Treadmill proform model 831.29605.0 (proform xp 550e was working fine till I Changed the walk belt. After changing belt, display looked ok but treadmiil would non trurn on. Operated incline. incline


1) i recommend that you lube very well deck belt + rollers bearing

2) see the videos.

3) see the block

4) Try to RUN the software calibration, for troubleshooting.

5) measure the input voltage motor, if there are the motor need repair.
6) Measure the output voltage board, for input voltage board, if there are NOT, the board is faulty.
6_28_2012_5_29_07_pm.gif

Jun 27, 2012 | Proform Treadmill Motor Controller 241697

1 Answer

Proform crosswalk 515 control board works but belt won't move/


lube the deck belt, you have deck worn, proceed in according with the instruction manual maintenance. 2) check the drive belt and replace it if necessary and tight 3) tes the input voltage motor, if there are the motor need repair or replace 4) test the output voltage from main board, for input voltage for the main motor, if there are NOT, the board is faulty.
Try if you can RUN the software calibration for diagnose and troubleshooting.
sincerely. God bless you.

Apr 28, 2012 | Proform Crosswalk 500 Treadmill

1 Answer

My Proform XP 650e Treadmill starts and suddenly stops. The belt turns real fast then it suddenly shuts down like the power was turned off.


This condition is when the treadmill goes to full speed as soon as you power up the treadmill. Typically when this occurs, it is an indication of a short circuit in the motor controller.

Jun 28, 2010 | Proform XP Weight Loss 620 Treadmill

1 Answer

I have a proform xp 550s treadmill. The belt


change drive belt proform xp 550s treadmill

Aug 26, 2009 | Exercise & Fitness

1 Answer

Motor belt replacemnt


visit www.iconfitness.com. they have instructions online. just enter your product information. we can help if you are in Texas.

Aug 07, 2009 | Proform CrossTrainer Treadmill

Not finding what you are looking for?
Proform CrossTrainer Treadmill Logo

1,854 people viewed this question

Ask a Question

Usually answered in minutes!

Top Proform Exercise & Fitness Experts

Ross Metcalfe
Ross Metcalfe

Level 2 Expert

128 Answers

Matt Olenzek
Matt Olenzek

Level 2 Expert

293 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6694 Answers

Are you a Proform Exercise and Fitnes Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...