Question about RTO Oar Sockets

1 Answer

Yamaha 50hp outboard

There is water coming from the three outlets at the back of the outboard the exhaust and the other 2 as well as the pump outlet is this normal or is there a problem ? and what could it be ??

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 154 Answers

Its working fine

Posted on Aug 03, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

4ohrp mercery outboard over heats


water pump impeller failure check tell water outlet for flow
blocked water inlet holes
corroded plate in the block between coolant and exhaust allowing exhaust gas into the coolant
corroded cylinders

May 28, 2017 | Boating

1 Answer

How to install a evenrude outboard water pump


the exhaust ports start from the side of the engine block 2hp -90hp then v4 and v6 and v8 are between the v blocks ! from there they go down the leg unit , top rear of leg have an outlet for tickover then the main outlet is either through the prop or above it on small or old type engines !

May 09, 2014 | Boating

2 Answers

Yamaha 50 outboard bogs at hi speed


Make sure carbs are clean,check exhaust tube isn't blocked,check resistance readings on charge coil,make sure filters are clean,no fuel leaks in fuel line,tank has open breather,fuel connector not blocked.if this doesn't solve the problem could be faulty cdi unit

Sep 25, 2013 | Clymer Marine Maintenance and Repair...

2 Answers

I have a evinrude 28hp outboard which is not pumping water. drive shaft seems in place and impeller in good nick. have put hose at bottom of inlet pipe and water runs through motor and out outlet. water...


Check pump housing and plate for wear,make sure aluminium housing not corroded under plate. Suggest fitting electric drill to drive shaft and emerse lower unit in bucket of water.make sure drill doesn't get wet.is motor going into gear,maybe splines are rusted off in crankshaft,could also have holes in inner exhaust side plate

Sep 04, 2013 | Sierra International 18-4310 Marine...

1 Answer

50hp mercury marine outboard


put a water pump kit in it

May 26, 2013 | Boating

1 Answer

1982 55 yamaha outboard ,water not coming out the water pump hole in strenght


First thing to check: Disconnect the tiny hose between the check outlet and the engine. Disconnect it at the engine side.
With an airgun, blow in the check hole from outside to engine side.
With an airgun, blow out the engine connection.
Start the engine, check waterflow out of the engine connector. If water, reconnect the hose and check the water at the checkpoint.
If still no water at the engine connection: replace the impeller!

Mar 28, 2013 | Clymer Marine Maintenance and Repair...

1 Answer

My Yamaha 4 stroke 50hp engine was running fine. When i went to replace the cover, the water stopped running through the "pee" hole.


i have had this on mine and it was a sort of insect that made a mud nest in the small hole and it blocked the hole up ,try poking it out with a bit of wire

Jun 24, 2011 | Clymer Marine Maintenance and Repair...

1 Answer

I want to sound proof the engine cowing on a 50hp outboard


Marine stores have a lead lined foam sound proofing mat. You can cut and glue it in place.

Apr 28, 2009 | Yamaha 12V Air Pump

Not finding what you are looking for?
RTO Oar Sockets Logo

Related Topics:

1,339 people viewed this question

Ask a Question

Usually answered in minutes!

Top RTO Boating Experts

merc racing

Level 1 Expert

36 Answers

Mike

Level 3 Expert

4350 Answers

ffstaffsta
ffstaffsta

Level 2 Expert

103 Answers

Are you a RTO Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...