Remove complete shaft assembly on a robot coupe mp450 turbo "b"

Question edited for clarity 'Robo Coupe' is two words.
Question moved from Cars and Trucks category.

Just one video on seals.

https://www.google.com/search?q=robot+coupe%2C+replace+motor+seal+bushing

..

might be the start switch in the motor and or a capacitor. it should turn fairly freely by hand, if not it could be a bad bearing/bushing.

First you drill out the plastic plugs to acess the torx screws holding the housing together. Remove 4 motor mounting screws to separate from shaft.

You have to drill out the little plastic plugs to get to the torx screws holding the housing together

I need a wiring diagram too don' Robot Coupe have service info. on their products as expensive as they are it's a problem. Robot Coupe MP450 Turbo can't seem to find anywhere. Thanks

There is an exploded diagram here which should show how it dismantles
http://parts.robotcoupe.net/mp450.html
Not sure where you are geographically but hope that helps.
You can buy the bearings, I  was going to suggest that it wasn't worth repairing and then I checked the price of a new one!!!!  It is worth repairing I can't believe how expensive they are! Good Luck

we found the solution to the problem on your website.
Thank's for the tip.

4 screws are covered by caps in the handle area, everyone finds these but there are a further 4 screws found by removing the air vent grilles. The grilles are held in place along their shorter sides midway. Pop a fine screwdriver in at this point and the grille comes off.

http://www.retrevo.com/support/Robot-Coupe-MP450Turbo-Food-Processors-manual/id/23109bh930/t/2/
Hope this helps you can download it by PDF

If you type in your model number on the internet information will come up on it for parts & other things. Hope this helps